- 您現在的位置：買賣IC網 > PDF目錄379182 > DS2151 T1 Single-Chip Transceiver PDF資料下載
參數資料
| 型號： | DS2151 |
| 英文描述： | T1 Single-Chip Transceiver |
| 中文描述： | T1單芯片收發器 |
| 文件頁數： | 5/51頁 |
| 文件大?。?/td> | 1100K |
| 代理商： | DS2151 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
DS2151Q
5 of 51
PIN
19
SYMBOL
ACLKI
TYPE
I
DESCRIPTION
Alternate Clock Input.
Upon a receive carrier loss, the clock applied at
this pin (normally 1.544 MHz) will be routed to the RCLK pin. If no
clock is routed to this pin, then it should be tied to DVSS VIA A1K Ohm
RESISTOR.
Bus Type Select.
Strap high to select Motorola bus timing; strap low to
select Intel bus timing. This pin controls the function of the
RD
(DS),
ALE(AS), and
WR
(R/
W
) pins. If BTS=1, then these pins assume the
function listed in parenthesis ().
Receive Tip and Ring.
Analog inputs for clock recovery circuitry;
connects to a 1:1 transformer (see Section 12 for details).
Receive Analog Positive Supply
. 5.0 volts. Should be tied to DVDD
and TVDD pins.
Receive Signal Ground
. 0.0 volts. Should be tied to local ground plane
Crystal Connections.
A pullable 6.176 MHz crystal must be applied to
these pins. See Section 12 for crystal specifications.
Receive Alarm Interrupt 1.
Flags host controller during alarm
conditions defined in Status Register 1. Active low, open drain output.
Receive Alarm Interrupt 2.
Flags host controller during conditions
defined in Status Register 2. Active low, open drain output.
Transmit Tip.
Analog line driver output; connects to a step-up
transformer (see Section 12 for details).
Transmit Signal Ground.
0.0 volts. Should be tied to local ground
plane.
Transmit Analog Positive Supply.
5.0 volts. Should be tied to DVDD
and RVDD pins.
Transmit Ring
. Analog line driver outputs; connects to a step-up
transformer (see Section 12 for details).
Transmit Channel Block
. A user programmable output that can be
forced high or low during any of the 24 T1 channels. Useful for blocking
clocks to a serial UART or LAPD controller in applications where not all
T1 channels are used such as Fractional T1, 384k bps service, 768k bps,
or ISDN-PRI. Also useful for locating individual channels in drop-and-
insert applications. See Section 13 for timing details.
Transmit Link Clock.
4 kHz or 2 kHz (ZBTSI) demand clock for the
TLINK input. See Section 13 for timing details.
Transmit Link Data.
If enabled via TCR1.2, this pin will be sampled
during the F-bit time on the falling edge of TCLK for data insertion into
either the FDL stream (ESF) or the Fs bit position (D4) or the Z-bit
position (ZBTSI). See Section 13 for timing details.
Transmit Sync.
A pulse at this pin will establish either frame or
multiframe boundaries for the DS2151Q. Via TCR2.2, the DS2151Q can
be programmed to output either a frame or multiframe pulse at this pin. If
this pin is set to output pulses at frame boundaries, it can also be set via
TCR2.4 to output double-wide pulses at signaling frames. See Section 13
for timing details.
Digital Positive Supply.
5.0 volts. Should be tied to RVDD and TVDD
pins.
20
BTS
I
21
22
23
RTIP
RRING
RVDD
-
-
24
25
26
27
RVSS
XTAL1
XTAL2
-
-
INT1
O
28
INT2
O
29
TTIP
-
30
TVSS
-
31
TVDD
-
32
TRING
-
33
TCHBLK
O
34
TLCLK
O
35
TLINK
I
36
TSYNC
I/O
37
DVDD
-
相關PDF資料 |
PDF描述 |
|---|---|
| DS2154L | Enhanced E1 Single Chip Transceiver |
| DS2154LN | Enhanced E1 Single Chip Transceiver |
| DS2154 | WSD 151 SOLDERING STATION 230V UKWSD 151 SOLDERING STATION 230V UK; Frequency, supply max:60Hz; Frequency, supply min:50Hz; Height:101mm; Length:166mm; Power, input:150W; Temperature range:50(degree C) - 550(degree C); Voltage, |
| DS2155 | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
| DS2156 | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2151DK | 功能描述:KIT TRANSCEIVER T1 DESIGN DS2151 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| DS2151K | 功能描述:IC TXRX T1 1-CHIP 5V 44-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| DS2151Q | 制造商:DAL 功能描述:2151 DAL'95 NOTES 制造商:Maxim Integrated Products 功能描述:PCM TRANSCEIVER, Single, T-1(DS1), 44 Pin, Plastic, PLCC |
| DS2151Q/T&R | 制造商:Maxim Integrated Products 功能描述:IC TXRX T1 1-CHIP 5V LP 44-PLCC |
| DS2151Q/T&R | 功能描述:IC TXRX T1 1-CHIP 5V LP 44-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
發布緊急采購，3分鐘左右您將得到回復。