- 您現在的位置：買賣IC網 > PDF目錄380224 > CYRF69213 (Cypress Semiconductor Corp.) Programmable Radio on Chip Low Power PDF資料下載
參數資料
| 型號： | CYRF69213 |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | Programmable Radio on Chip Low Power |
| 中文描述： | 可編程片上無線電低功耗 |
| 文件頁數： | 29/85頁 |
| 文件大?。?/td> | 731K |
| 代理商： | CYRF69213 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁
CYRF69213
Document #: 001-07552 Rev. *B
Page 29 of 85
Sleep Mode
The CPU can only be put to sleep by the firmware. This is
accomplished by setting the Sleep bit in the System Status and
Control Register (CPU_SCR). This stops the CPU from
executing instructions, and the CPU will remain asleep until an
interrupt comes pending, or there is a reset event (either a
Power-on Reset, or a Watchdog Timer Reset).
The Low-voltage Detection circuit (LVD) drops into fully
functional power-reduced states, and the latency for the LVD
is increased. The actual latency can be traded against power
consumption by changing the Sleep Duty Cycle field of the
ECO_TR Register.
The Internal 32-KHz Low-speed Oscillator remains running.
Prior to entering suspend mode, firmware can optionally
configure the 32-KHz Low-speed Oscillator to operate in a
low-power mode to help reduce the overall power
consumption (using Bit 7,
Table 32
). This will help save
approximately 5
μ
A; however, the trade off is that the 32-KHz
Low-speed Oscillator will be less accurate.
All interrupts remain active. Only the occurrence of an interrupt
will wake the part from sleep. The Stop bit in the System Status
and Control Register (CPU_SCR) must be cleared for a part
to resume out of sleep. The Global Interrupt Enable bit of the
CPU Flags Register (CPU_F) does not have any effect. Any
unmasked interrupt will wake the system up. As a result, any
interrupts not intended for waking must be disabled through
the Interrupt Mask Registers.
When the CPU enters sleep mode the CPUCLK Select (Bit 1,
Table 33
) is forced to the Internal Oscillator. The internal oscil-
lator recovery time is three clock cycles of the Internal 32-KHz
Low-power Oscillator. The Internal 24-MHz Oscillator restarts
immediately on exiting Sleep mode. If an external clock is
used, firmware will need to switch the clock source for the
CPU.
On exiting sleep mode, once the clock is stable and the delay
time has expired, the instruction immediately following the
sleep instruction is executed before the interrupt service
routine (if enabled).
The Sleep interrupt allows the microcontroller to wake up
periodically and poll system components while maintaining
very low average power consumption. The Sleep interrupt
may also be used to provide periodic interrupts during
non-sleep modes.
Sleep Sequence
The SLEEP bit is an input into the sleep logic circuit. This
circuit is designed to sequence the device into and out of the
hardware sleep state. The hardware sequence to put the
device to sleep is shown in
Figure 12
and is defined as follows.
1. Firmware sets the SLEEP bit in the CPU_SCR0 register.
The Bus Request (BRQ) signal to the CPU is immediately
asserted. This is a request by the system to halt CPU op-
eration at an instruction boundary. The CPU samples BRQ
on the positive edge of CPUCLK.
2. Due to the specific timing of the register write, the CPU
issues a Bus Request Acknowledge (BRA) on the following
positive edge of the CPU clock. The sleep logic waits for
the following negative edge of the CPU clock and then
asserts a system-wide Power Down (PD) signal. In
Figure 12
the CPU is halted and the system-wide power
down signal is asserted.
3. The system-wide PD (power down) signal controls several
major circuit blocks: The Flash memory module, the internal
24-MHz oscillator, the EFTB filter and the bandgap voltage
reference. These circuits transition into a zero power state.
The only operational circuits on chip are the Low Power
oscillator, the bandgap refresh circuit, and the supply
voltage monitor (POR/LVD) circuit.
Note
To achieve the lowest possible power consumption
during suspend/sleep, the following conditions must be
observed in addition to considerations for the sleep timer.
All GPIOs must be set to outputs and driven low
The USB pins P1.0 and P1.1 should be configured as inputs
with their pull ups enabled.
Table 39.Reset Watchdog Timer (RESWDT) [0xE3] [W]
Bit #
Field
Read/Write
Default
Any write to this register will clear Watchdog Timer, a write of 0x38 will also clear the Sleep Timer
Bits 7:0
Reset Watchdog Timer [7:0]
7
6
5
4
3
2
1
0
Reset Watchdog Timer [7:0]
W
0
W
0
W
0
W
0
W
0
W
0
W
0
W
0
[+] Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| CYRF69213-40LFXC | Programmable Radio on Chip Low Power |
| CYRF6936-40LFXC | WirelessUSB⑩ LP 2.4 GHz Radio SoC |
| CYS25G0101DX-ATC | SONET OC-48 Transceiver |
| CYS25G0101DX-ATI | SONET OC-48 Transceiver |
| CYS25G0101DX-ATXC | SONET OC-48 Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CYRF69213_08 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Programmable Radio on Chip Low Power |
| CYRF69213_13 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Programmable Radio on Chip Low Power |
| CYRF69213-40LFXC | 功能描述:射頻接收器 PRoC LP COM RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| CYRF69213-40LTXC | 功能描述:8位微控制器 -MCU Programmable Radio on Chip Low Power RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| CYRF69213A-40LFXC | 功能描述:8位微控制器 -MCU Programmable Radio on Chip Low Power RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。