- 您現在的位置：買賣IC網 > PDF目錄223308 > ADE7878ACPZ-RL (ANALOG DEVICES INC) Poly Phase Multifunction Energy Metering IC With Total And Fundamental Powers, No Of Pins: 40, Temperature Range: Ind PDF資料下載
參數資料
| 型號： | ADE7878ACPZ-RL |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | Poly Phase Multifunction Energy Metering IC With Total And Fundamental Powers, No Of Pins: 40, Temperature Range: Ind |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, QCC40 |
| 封裝： | 6 X 6 MM, ROHS COMPLIANT, MO-220WJJD, LFCSP-40 |
| 文件頁數： | 41/96頁 |
| 文件大?。?/td> | 1096K |
| 代理商： | ADE7878ACPZ-RL |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
ADE7854/ADE7858/ADE7868/ADE7878
Rev. E | Page 46 of 96
The output is scaled by 50% by writing 0xC00000 to the watt
gain registers, and it is increased by +50% by writing 0x400000
to them. These registers are used to calibrate the active power
(or energy) calculation in the ADE7854/ADE7858/ADE7868/
ADE7878 for each phase.
As stated in the Current Waveform Gain Registers section, the
serial ports of the ADE7854/ADE7858/ADE7868/ADE7878
work on 32-, 16-, or 8-bit words, and the DSP works on 28 bits.
Similar to registers presented in Figure 33, AWGAIN, BWGAIN,
CWGAIN, AFWGAIN, BFWGAIN, and CFWGAIN 24-bit
signed registers are accessed as 32-bit registers with the four
MSBs padded with 0s and sign extended to 28 bits.
Active Power Offset Calibration
The ADE7854/ADE7858/ADE7868/ADE7878 incorporate a
watt offset 24-bit register on each phase and on each active
power. The AWATTOS, BWATTOS, and CWATTOS registers
compensate the offsets in the total active power calculations,
and the AFWATTOS, BFWATTOS, and CFWATTOS registers
compensate offsets in the fundamental active power calculations.
These are signed twos complement, 24-bit registers that are
used to remove offsets in the active power calculations. An
offset can exist in the power calculation due to crosstalk between
channels on the PCB or in the chip itself. One LSB in the active
power offset register is equivalent to 1 LSB in the active power
multiplier output. With full-scale current and voltage inputs,
the LPF2 output is PMAX = 33,516,139. At 80 dB down from
the full scale (active power scaled down 104 times), one LSB of
the active power offset register represents 0.0298% of PMAX.
As stated in the Current Waveform Gain Registers section, the
serial ports of the ADE7854/ADE7858/ADE7868/ADE7878
work on 32-, 16-, or 8-bit words and the DSP works on 28 bits.
Similar to registers presented in Figure 33, the AWATTOS,
BWATTOS, CWATTOS, AFWATTOS, BFWATTOS, and
CFWATTOS 24-bit signed registers are accessed as 32-bit
registers with the four MSBs padded with 0s and sign extended
to 28 bits.
Sign of Active Power Calculation
The average active power is a signed calculation. If the phase
difference between the current and voltage waveform is more
than 90°, the average power becomes negative. Negative power
indicates that energy is being injected back on the grid. The
ADE78xx has sign detection circuitry for total active power
calculations. It can monitor the total active powers or the
fundamental active powers. As described in the Active Energy
Calculation section, the active energy accumulation is performed
in two stages. Every time a sign change is detected in the energy
accumulation at the end of the first stage, that is, after the energy
accumulated into the internal accumulator reaches the WTHR
register threshold, a dedicated interrupt is triggered. The sign of
each phase active power can be read in the PHSIGN register.
Bit 6 (REVAPSEL) in the ACCMODE register sets the type of
active power being monitored. When REVAPSEL is 0, the
default value, the total active power is monitored. When
REVAPSEL is 1, the fundamental active power is monitored.
Bits[8:6] (REVAPC, REVAPB, and REVAPA, respectively) in the
STATUS0 register are set when a sign change occurs in the
power selected by Bit 6 (REVAPSEL) in the ACCMODE
register.
Bits[2:0] (CWSIGN, BWSIGN, and AWSIGN, respectively) in
the PHSIGN register are set simultaneously with the REVAPC,
REVAPB, and REVAPA bits. They indicate the sign of the power.
When they are 0, the corresponding power is positive. When
they are 1, the corresponding power is negative.
Bit REVAPx of STATUS0 and Bit xWSIGN in the PHSIGN
register refer to the total active power of Phase x, the power type
being selected by Bit 6 (REVAPSEL) in the ACCMODE register.
Interrupts attached to Bits[8:6] (REVAPC, REVAPB, and REVAPA,
respectively) in the STATUS0 register can be enabled by setting
Bits[8:6] in the MASK0 register. If enabled, the IRQ0 pin is set
low, and the status bit is set to 1 whenever a change of sign occurs.
To find the phase that triggered the interrupt, the PHSIGN register
is read immediately after reading the STATUS0 register. Next, the
status bit is cleared and the IRQ0 pin is returned to high by writing
to the STATUS0 register with the corresponding bit set to 1.
Active Energy Calculation
As previously stated, power is defined as the rate of energy flow.
This relationship can be expressed mathematically as
dt
dEnergy
Power =
(23)
Conversely, energy is given as the integral of power, as follows:
()dt
t
p
Energy
∫
=
(24)
Total and fundamental active energy accumulations are always
signed operations. Negative energy is subtracted from the active
energy contents.
相關PDF資料 |
PDF描述 |
|---|---|
| ADG529FTQ | 4-CHANNEL, DIFFERENTIAL MULTIPLEXER, CDIP18 |
| ADJ24006 | POWER/SIGNAL RELAY, SPST, LATCHED, 0.042A (COIL), 6VDC (COIL), 250mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| ADJ24012 | POWER/SIGNAL RELAY, SPST, LATCHED, 0.021A (COIL), 12VDC (COIL), 250mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| ADJ24024 | POWER/SIGNAL RELAY, SPST, LATCHED, 0.01A (COIL), 24VDC (COIL), 250mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
| ADJ24048 | POWER/SIGNAL RELAY, SPST, LATCHED, 0.005A (COIL), 48VDC (COIL), 250mW (COIL), THROUGH HOLE-STRAIGHT MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADE7878XCPZ | 制造商:Analog Devices 功能描述:POLY PHASE MULTIFUNCTION ENERGY METERING IC WITH TOTAL - Bulk |
| ADE7880 | 制造商:Analog Devices 功能描述:BOARD EVAL ENERGY METER ADE |
| ADE7880ACPZ | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 能量測量 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:* |
| ADE7880ACPZ-RL | 功能描述:IC ENERGY METERING 3PH 40LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 能量測量 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:* |
| ADE7903ARWZ | 功能描述:Energy Monitor (Power Meter) 24 bit SPI 20-SOIC 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 類型:能量監測器（功率計） 分辨率（位）:24 b 采樣率（每秒）:- 數據接口:SPI 電壓源:單電源 電壓 - 電源:2.97 V ~ 3.63 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 供應商器件封裝:20-SOIC 標準包裝:37 |
發布緊急采購，3分鐘左右您將得到回復。