參數資料
型號: ST52T301P
廠商: 意法半導體
英文描述: 8-Bit OTP/EPROM DuaLogic] MCUs WITH ADC, UART, TIMER, TRIAC & PWM DRIVER
中文描述: 8位檢察官辦公室/存儲器DuaLogic]與藝術發展局和UART,定時器,可控硅控制器
文件頁數: 46/100頁
文件大?。?/td> 497K
代理商: ST52T301P
D7 D6 D5 D4 D3 D2 D1 D0
REG_CONF8
TRIAC / PWM
TCLSB - Prescaler init value
Least Significative Bits
D7 D6 D5 D4 D3 D2 D1 D0
REG_CONF9
TRIAC / PWM
TCMSB - Prescaler init value
Most Significative Bits
Figure10.2.TRIAC/PWMConfigurationRegister 8 and 9
The PWM period can be generated, internally, by
dividingthe masterclockor,externally,byusingan
externalclock signal.
Inbothcases,theclocksignalis dividedbya 16-bit
Prescaler, managed by REG_CONF8 and
REG_CONF9(see Figure 10.2).
Thedutycycleis fixedbya value,thatcanbe either
the output of a fuzzyinference or the result of an
arithmetic calculus. In the first case, it can be
loaded directly in the register of the peripheral,
otherwise it can be stored in one location of the
Register File for further manipulations and then
used forthe controlof the PWM.
Burst Mode
It is based on turning on and off the TRIAC, for a
fixed integer number of main voltage periods, in
order to controlthe power transferredto the load.
For this reason a Burst Mode TRIAC control
consistsof a signal,with a period,T,containingan
integernumberof themainvoltageperiods,whose
duty cycle is proportional to the numberof periods
inwhichthe TRIACis ON(Duty Cycle).Thiskindof
Triac control is mainly used for thermal regulation.
Thedutycycleisfixedbyavaluethatcanbedirectly
the output of a fuzzyinference or the result of an
arithmeticcalculus.
In order to work in Burstmode, it is necessary to
detect the pre-post zero-crossingof main voltage,
by using an externalinsertingcircuitry.
The user can define the period T, by means of the
internal 16-bit prescaler, setting REG_CONF8 and
REG_CONF9(see Figure10.2).T isproportionalto
the main voltage period, it is in the range 0 to 21.8
sec(if themain frequencyis 50Hz).
The width and the polarity of the pulses can be
programmed according to the Triac and the circuit
characteristics.
Phase Angle PartializationMode
Thismethodis basedon turningon theTRIAConly
for a part (phase angle) of each main voltage
period.When the phase angle is large the energy
(power)suppliedto theloadis low,viceversa,when
thephaseangleis smallthe energysuppliedto the
load is high.
The phaseangle can be fixed bya fuzzyalgorithm
or by a value stored in the Register File.
The phase angle is an 8-bit value.
The peripheral is programmable in order to work
witha main voltagefrequencyof 50 or 60 Hz.
46/99
ST52T301/E301
相關PDF資料
PDF描述
ST5451D ISDN HDLC AND GCI CONTROLLER
ST5481 L.O.U.I.S - LOW COST USB ISDN SOLUTION
ST5481TQF7 L.O.U.I.S - LOW COST USB ISDN SOLUTION
ST5x86 100 and 120 MHz 3.45 Volt 5x86 CPU(微處理器)
ST62 SERIES 8-Bit OTP/EPROM MCUs with A/D Converter, Oscilator Safeguard, Safe Reset and 20 Pins(8位OTP/EPROM微控制器(8M))
相關代理商/技術參數
參數描述
ST52T400 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F0B6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F0M6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F1B6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F1M6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG