- 您現在的位置：買賣IC網 > PDF目錄369993 > pentium processor with MMX (Intel Corp.) 32-bit processor with MMX technology(32位帶MMX技術處理器) PDF資料下載
參數資料
| 型號： | pentium processor with MMX |
| 廠商： | Intel Corp. |
| 英文描述： | 32-bit processor with MMX technology(32位帶MMX技術處理器) |
| 中文描述： | 32位MMX技術（32位帶MMX公司的技術處理器處理器） |
| 文件頁數： | 29/51頁 |
| 文件大?。?/td> | 479K |
| 代理商： | PENTIUM PROCESSOR WITH MMX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
E
specified at different voltages. See Table 10 for the
specification.
PENTIUM PROCESSOR WITH MMX TECHNOLOGY
29
5/23/97 10:47 AM 24318502.DOC
The display should show continuous sampling of the
voltage line, at 20 mV/div, and 500 ns/div with the
trigger point set to the center point of the range.
Slowly move the trigger to the high and low ends of
the specification, and verify that excursions beyond
these limits are not observed. There are no
allowances for crossing the high and low limits of the
voltage specification. For more information on
measurement
techniques,
Guidelines for Pentium
Processors with MMX
Technology
application note (Order Number 243186).
see
the
Voltage
3.1.2.1.2.
Decoupling Recommendations
Liberal decoupling capacitance should be placed
near the Pentium processor with MMX technology.
The Pentium processor with MMX technology, when
driving its large address and data buses at high
frequencies, can cause transient power surges,
particularly when driving large capacitive loads.
Low inductance capacitors and interconnects are
recommended for best high frequency electrical
performance. Inductance can be reduced by
shortening circuit board traces between the Pentium
processor with MMX technology and decoupling
capacitors as much as possible. These capacitors
should be evenly distributed around each component
on the power plane. Capacitor values should be
chosen to ensure they eliminate both low and high
frequency noise components.
For the Pentium processor with MMX technology, the
power consumption can transition from a low level of
power to a much higher level (or high to low power)
very rapidly. A typical example would be entering or
exiting the Stop Grant State. Another example would
be executing a HALT instruction, causing the
Pentium processor with MMX technology to enter the
AutoHALT Power Down State, or transitioning from
HALT to the Normal State. All of these examples
may cause abrupt changes in the power being
consumed by the Pentium processor with MMX
technology. Note that the AutoHALT Power Down
feature is always enabled even when other power
management features are not implemented.
Bulk storage capacitors with a low Effective Series
Resistance (ESR) in the 10
to 100
range are
required to maintain a regulated supply voltage
during the interval between the time the current load
changes and the point that the regulated power
supply output can react to the change in load. In
order to reduce the ESR, it may be necessary to
place several bulk storage capacitors in parallel.
These capacitors should be placed near the Pentium
processor with MMX technology on both the V
CC2
and V
CC3
plane to ensure that the supply voltage
stays within specified limits during changes in the
supply current during operation.
Detailed decoupling recommendations are provided
in the Flexible Motherboard Design Guidelines
application note (Order Number 243187)
3.1.2.2.
3.3V Inputs and Outputs
The inputs and outputs of the Pentium processor with
MMX technology comply with the 3.3V JEDEC
standard levels. Both inputs and outputs are also
TTL-compatible, although the inputs cannot tolerate
voltage swings above the V
IN3
(max) specification.
System support components which use TTL-
compatible inputs will interface to the Pentium
processor with MMX technology without extra logic.
This is because the Pentium processor drives
according to the 5V TTL specification (but not
beyond 3.3V).
For Pentium processor with MMX technology inputs,
the voltage must not exceed the 3.3V V
IN3
(max)
specification. System support components can
consist of 3.3V devices or open-collector devices. In
an open-collector configuration, the external resistor
should be biased to V
CC3
.
All pins, including the CLK and PICCLK of the
Pentium processor with MMX technology, are 3.3V-
tolerant-only. If an 8259A interrupt controller is used,
for example, the system must provide level
converters between the 8259A and the Pentium
processor with MMX technology.
3.1.2.3.
NC/INC and Unused Inputs
All NC and INC pins must remain unconnected.
For reliable operation, always connect unused inputs
to an appropriate signal level. Unused active low
inputs should be connected to V
CC3
. Unused active
high inputs should be connected to V
SS
(ground).
相關PDF資料 |
PDF描述 |
|---|---|
| pentium processor | 32 Bit Processor With MMX And Mobile Module(32位帶移動模塊和MMX技術CPU) |
| PESD0603-140 | Raychem Overvoltage Devices |
| PESD5V2S18U | ESD protection array |
| PESDXL4UW | Low capacitance quadruple ESD protection array |
| PESDXL4UG | Low capacitance quadruple ESD protection diode array in SOT353 package |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P-ENV568K3G3 | 制造商:Panasonic Industrial Company 功能描述:TUNER |
| PEO14012 | 制造商:TE Connectivity 功能描述:RELAY SPCO 12VDC |
| PEO14024 | 制造商:TE Connectivity 功能描述:RELAY SPCO 24VDC |
| PEO96742 | 制造商:Delphi Corporation 功能描述:ASM TERM |
| PEOODO3A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
發布緊急采購，3分鐘左右您將得到回復。