參數資料
型號: MC145230
廠商: Motorola, Inc.
英文描述: Dual PLL Frequency Synthesizers With DACs and Voltage Multipliers(帶DACs和電壓乘法器的雙PLL頻率合成器)
中文描述: 雙鎖相環頻率合成器與DAC和電壓倍增器(帶數模轉換器和電壓乘法器的雙鎖相環頻率合成器)
文件頁數: 67/71頁
文件大?。?/td> 906K
代理商: MC145230
MC145225 MC145230
67
MOTOROLA RF/IF DEVICE DATA
shift time shown in Figure 64. Included in the first data set are
N23 = 1 which is required when the Mode pin is high, N22 = 0
for the lock detect window of 1.6
μ
s, and N18 = 0 for a current
ratio of 4:1 (because the phase detector is running at
approximately 4x the step size). Note that bits N23, N22, and
N18 are unchanged from the initialization values.
For the second data set, bits N23, N22, and N18 are
unchanged. Bits N21, N20, and N19 must be programmed as
001. This enables PDout–Lo for the exact tune after time out.
In summary, two data sets need to be sent to the device:
{R1, N1} and {R2, N2}. They are sent in succession as R1,
N1, R2, N2; where R1 is the R register value for the first data
set, N1 is the N register value for the first set, etc. For the
example, these values are {R1, N1} = {$0115, $A8321A} and
{R2, N2} = {$0510, $88EA69}. See Figure 64.
Tuning Other Channels
Tuning other channels for the main loop, while keeping the
secondary loop at a constant frequency, requires sending
two data sets to the part {R1, N1} and {R2, N2}. See Table 23.
8E. CONTROLLING THE DACs
Introduction
The two 8–bit DACs are independent circuit blocks on the
chip. They have no interaction with other circuits on the chip.
A single 16–bit register, called the D register, holds the binary
value which controls both DACs.
Programming the DACs
A DAC programmed for 0 scale is in the low–power mode.
The 0 scale is programmed as $00 for each 8–bit DAC.
As an example, consider a system that uses just one of the
DACs (DAC 1). The other DAC output is unused and is
programmed for 0 output. If a condition for a system requires
that the DAC have a half–scale output, then DAC 1 is
programmed as $80.
In summary, $03000080 is serially transferred
(conventional access with an address of 0011).
Table 23. Main Loop Tuning Using Horseshoe With Adapt
ááááááááááááááááááá
ááááááááááááááááááá
á
áááááááááááááááá
áááááááááááááááááááá
áááááááááááááááááááá
áááááááááááááááááááá
áááááááááááááááááááá
áááááááááááááá
Target
Approximate Tuning
áááá
ááááááá
ááááááá
ááááááá
ááááááá
ááááááá
Exact Tuning
áá
á
áá
á
áá
á
(Hz)
ááá
á
Frequency
Error
áá
á
áá
á
áááááááááááááááááááá
相關PDF資料
PDF描述
MC14528BCL Dual Monostable Multivibrator
MC14528 DEFLECTION PROCESSOR FOR MULTISYNC MONITORS
MC14528 Dual Monostable Multivibrator
MC14528BFEL Dual Monostable Multivibrator
MC14528BCP Dual Monostable Multivibrator
相關代理商/技術參數
參數描述
MC14526B AC7 WAF 制造商:ON Semiconductor 功能描述:
MC14526BAC7 WAF 制造商:ON Semiconductor 功能描述:
MC14526BCL 制造商: 功能描述: 制造商:undefined 功能描述:
MC14526BCP 功能描述:計數器移位寄存器 3-18V Presettable RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel
MC14526BCPG 功能描述:計數器移位寄存器 3-18V Presettable 4-Bit Down RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel