- 您現在的位置：買賣IC網 > PDF目錄1917 > DSPB56362AG120 (Freescale Semiconductor)IC DSP 24BIT AUD 120MHZ 144-LQFP PDF資料下載
參數資料
| 型號： | DSPB56362AG120 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 66/152頁 |
| 文件大小： | 0K |
| 描述： | IC DSP 24BIT AUD 120MHZ 144-LQFP |
| 標準包裝： | 60 |
| 系列： | DSP56K/Symphony |
| 類型： | 音頻處理器 |
| 接口： | 主機接口，I²C，SAI，SPI |
| 時鐘速率： | 120MHz |
| 非易失內存： | ROM（126 kB） |
| 芯片上RAM： | 42kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 3.30V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 144-LQFP |
| 供應商設備封裝： | 144-LQFP（20x20） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁
Serial Host Interface
DSP56362 Technical Data, Rev. 4
2-14
Freescale Semiconductor
2.8
Serial Host Interface
The SHI has five I/O signals that can be configured to allow the SHI to operate in either SPI or I2C mode.
Table 2-10 Serial Host Interface Signals
Signal Name
Signal Type
State during
Reset
Signal Description
SCK
SCL
Input or Output
Tri-Stated
SPI Serial Clock—The SCK signal is an output when the SPI is
configured as a master and a Schmitt-trigger input when the SPI is
configured as a slave. When the SPI is configured as a master, the
SCK signal is derived from the internal SHI clock generator. When the
SPI is configured as a slave, the SCK signal is an input, and the clock
signal from the external master synchronizes the data transfer. The
SCK signal is ignored by the SPI if it is defined as a slave and the slave
select (SS) signal is not asserted. In both the master and slave SPI
devices, data is shifted on one edge of the SCK signal and is sampled
on the opposite edge where data is stable. Edge polarity is determined
by the SPI transfer protocol.
I2C Serial Clock—SCL carries the clock for I2C bus transactions in the
I2C mode. SCL is a Schmitt-trigger input when configured as a slave
and an open-drain output when configured as a master. SCL should
be connected to VCC through a pull-up resistor.
This signal is tri-stated during hardware, software, and individual
reset. Thus, there is no need for an external pull-up in this state.
This input is 5 V tolerant.
MISO
SDA
Input or Output
Input or Open-Drain
Output
Tri-Stated
SPI Master-In-Slave-Out—When the SPI is configured as a master,
MISO is the master data input line. The MISO signal is used in
conjunction with the MOSI signal for transmitting and receiving serial
data. This signal is a Schmitt-trigger input when configured for the SPI
Master mode, an output when configured for the SPI Slave mode, and
tri-stated if configured for the SPI Slave mode when SS is deasserted.
An external pull-up resistor is not required for SPI operation.
I2C Data and Acknowledge—In I2C mode, SDA is a Schmitt-trigger
input when receiving and an open-drain output when transmitting.
SDA should be connected to VCC through a pull-up resistor. SDA
carries the data for I2C transactions. The data in SDA must be stable
during the high period of SCL. The data in SDA is only allowed to
change when SCL is low. When the bus is free, SDA is high. The SDA
line is only allowed to change during the time SCL is high in the case
of start and stop events. A high-to-low transition of the SDA line while
SCL is high is a unique situation, and is defined as the start event. A
low-to-high transition of SDA while SCL is high is a unique situation
defined as the stop event.
This signal is tri-stated during hardware, software, and individual
reset. Thus, there is no need for an external pull-up in this state.
This input is 5 V tolerant.
相關PDF資料 |
PDF描述 |
|---|---|
| DSPB56364AF100 | IC DSP 24BIT AUD 100MHZ 100-LQFP |
| DSPB56366AG120 | IC DSP 24BIT AUD 120MHZ 144-LQFP |
| DSPB56367AG150 | IC DSP 24BIT 150MHZ 144-LQFP |
| DSPB56371AF180 | IC DSP 24BIT 180MHZ 80-LQFP |
| DSPB56374AEC | IC DSP 24BIT 150MHZ 52-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSPB56362AG120 | 制造商:Freescale Semiconductor 功能描述:Digital Signal Processor IC DSP Type:Cor |
| DSPB56362PV100 | 制造商:Rochester Electronics LLC 功能描述:DIGITAL AUDIO DSP - Bulk |
| DSPB56362PV120 | 制造商:Rochester Electronics LLC 功能描述:DIGITAL AUDIO DSP - Bulk |
| DSPB56364AF100 | 功能描述:數字信號處理器和控制器 - DSP, DSC DSP56364 RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSPB56364FU100 | 制造商:Rochester Electronics LLC 功能描述:24 BIT AUDIO DSP - Bulk 制造商:Motorola Inc 功能描述: 制造商:MOTOROLA 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。