參數資料
型號: AM79C974KCW
廠商: ADVANCED MICRO DEVICES INC
元件分類: 微控制器/微處理器
英文描述: PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems
中文描述: 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP132
封裝: PLASTIC, QFP-132
文件頁數: 58/153頁
文件大?。?/td> 838K
代理商: AM79C974KCW
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁當前第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁
AMD
P R E L I M I N A R Y
58
Am79C974
Ethernet Power Savings Modes
The Am79C974’s Ethernet controller supports two hard-
ware power savings modes. Both are entered by driving
the
SLEEP
pin LOW.
The PCI interface section is not effected by
SLEEP
. In
particular, access to the PCI configuration space re-
mains possible. None of the configuration registers will
be reset by
SLEEP
. All I/O accesses to the Am79C974’s
Ethernet controller will result in a PCI target abort
response.
The first power saving mode is called coma mode. In
coma mode, the Am79C974 controller has no means to
use the network to automatically wake itself up. Coma
mode is enabled when the AWAKE bit in BCR2 is reset.
Coma mode is the default power down mode.
The second power saving mode is called snooze mode.
In snooze mode, enabled by setting the AWAKE bit in
BCR2 and driving the
SLEEP
pin LOW, the T-MAU re-
ceive circuitry will remain enabled even while the
SLEEP
pin is driven LOW. The
LNKST
output is the only
one of the LED pins that continues to function. The
LNKSTE bit must be set in BCR4 to enable indication of
a good 10BASE-T link if there are link beat pulses or
valid frames present. This
LNKST
pin can be used to
drive an LED and/or external hardware that directly con-
trols the
SLEEP
pin of the Am79C974 controller. This
configuration effectively wakes the system when there
is any activity on the 10BASE-T link. Snooze mode can
be used only if the T-MAU is the selected network port.
Link beat pulses are not transmitted during snooze
mode.
If the
REQ
output is active when the
SLEEP
pin is as-
serted, then the Am79C974 controller will wait until the
GNT
input is asserted. Next, the Am79C974 controller
will deassert the
REQ
pin and finally, it will internally en-
ter either the coma or snooze sleep mode.
Before the sleep mode is invoked, the Am79C974 con-
troller will perform an internal S_RESET. This
S_RESET operation will not affect the values of the BCR
registers or the PCI configuration space.
The
SLEEP
pin should not be asserted during power
supply ramp-up. If it is desired that
SLEEP
be asserted
at power up time, then the system must delay the asser-
tion of
SLEEP
until three CLK cycles after the comple-
tion of a valid pin
RST
operation.
Software Access
Ethernet PCI Configuration Registers
The Am79C974 controller supports the 64-byte header
portion of the configuration space as predefined by the
PCI specification revision 2.0. None of the device spe-
cific registers in locations 64 – 255 are used by the
Ethernet controller. The layout of the configuration reg-
isters in the header region is shown in the table below.
All registers required to identify the Am79C974 control-
ler and its function are implemented. Additional regis-
ters are used to setup the configuration of the
Am79C974 controller in a system.
相關PDF資料
PDF描述
AM79C975 PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
AM79C973 PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
AM79C973KCW PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
AM79C975KCW PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
AM79C973VCW PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
相關代理商/技術參數
參數描述
AM79C975 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY
AM79C975BKC\\W 制造商:Advanced Micro Devices 功能描述:
AM79C975BKC\W 制造商:Advanced Micro Devices 功能描述:
AM79C975BKD\\W 制造商:Advanced Micro Devices 功能描述:
AM79C975BKD\W 制造商:Advanced Micro Devices 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY 制造商:AMD (Advanced Micro Devices) 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY