參數資料
型號: 1893YI-10
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 網絡接口
英文描述: DATACOM, INTERFACE CIRCUIT, PQFP64
封裝: 10 X 10 MM, TQFP-64
文件頁數: 146/152頁
文件大小: 943K
代理商: 1893YI-10
Chapter 8
Management Register Set
ICS1893 Rev C 6/6/00
June, 2000
93
ICS1893 - Release
Copyright 2000, Integrated Circuit Systems, Inc.
All rights reserved.
8.12.3
Auto-Negotiation Progress Monitor (bits 17.13:11)
The Auto-Negotiation Progress Monitor consists of the Auto-Negotiation Complete bit (bit 17.4) and the
three Auto-Negotiation Monitor bits (bits 17.13:11). The Auto-Negotiation Progress Monitor continually
examines the state of the Auto-Negotiation Process State Machine and reports the status of
Auto-Negotiation using the three Auto-Negotiation Monitor bits. Therefore, the value of these three bits
provides the status of the Auto-Negotiation Process.
These three bits are initialized to logic zero in one of the following ways:
A reset (see Section 5.1, “Reset Operations”)
Disabling Auto-Negotiation [see Section 8.2.4, “Auto-Negotiation Enable (bit 0.12)”]
Restarting Auto-Negotiation [see Section 8.2.7, “Restart Auto-Negotiation (bit 0.9)”]
If Auto-Negotiation is enabled, these bits continually latch the highest state that the Auto-Negotiation State
Machine achieves. That is, they are updated only if the binary value of the next state is greater than the
binary value of the present state as outlined in Table 8-19.
Note:
An MDIO read of these bits provides a history of the greatest progress achieved by the
auto-negotiation process. In addition, the MDIO read latches the present state of the
Auto-Negotiation State Machine for a subsequent read.
8.12.4
100Base-TX Receive Signal Lost (bit 17.10)
The 100Base-TX Receive Signal Lost bit indicates to an STA whether the ICS1893 has lost its 100Base-TX
Receive Signal. If this bit is set to a logic:
Zero, it indicates the Receive Signal has remained valid since either the last read or reset of this register.
One, it indicates the Receive Signal was lost since either the last read or reset of this register.
This bit is a latching high bit. (For more information on latching high and latching low bits, see Section
8.1.4.1, “Latching High Bits”and Section 8.1.4.2, “Latching Low Bits”.)
Note:
This bit has no definition in 10Base-T mode.
Table 8-19.
Auto-Negotiation State Machine (Progress Monitor)
Auto-Negotiation State Machine
Auto-Negotiation Progress Monitor
Auto-
Negotiation
Complete Bit
(Bit 17.4)
Auto-
Negotiation
Monitor Bit 2
(Bit 17.13)
Auto-
Negotiation
Monitor Bit 1
(Bit 17.12)
Auto-
Negotiation
Monitor Bit 0
(Bit 17.11)
Idle
0
Parallel Detected
0
1
Parallel Detection Failure
0
1
0
Ability Matched
0
1
Acknowledge Match Failure
0
1
0
Acknowledge Matched
0
1
0
1
Consistency Match Failure
0
1
0
Consistency Matched
0
1
Auto-Negotiation Completed
Successfully
1
0
相關PDF資料
PDF描述
1894-40KLF DATACOM, INTERFACE CIRCUIT, QCC40
1894-40KLFT DATACOM, INTERFACE CIRCUIT, QCC40
1895230000 15 A, STRIP TERMINAL BLOCK, 2 ROWS, 2 DECKS
18F-08P-241 8 CONTACT(S), CABLE MOUNT, MINI DIN CONNECTOR, PLUG
18F-08P-244 8 CONTACT(S), CABLE MOUNT, MINI DIN CONNECTOR, PLUG
相關代理商/技術參數
參數描述
1893YI-10LF 功能描述:以太網 IC 3.3V 10/100 BASE TX INTEGRATED PHYCEIVER RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
1893YI-10LFT 功能描述:以太網 IC 3.3V 10/100 BASE TX INTEGRATED PHYCEIVER RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
1894 功能描述:支架與墊片 HEX .187X.625 ALUM RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc
1894# 制造商:Fluke Electronics 功能描述:BNC (F)/BANANA PLUG 制造商:Pomona Electronics 功能描述:
1894 制造商:Pomona Electronics 功能描述:ADAPTER BNC FEMALE-BANANA PLUG 制造商:Pomona Electronics 功能描述:ADAPTER, BNC FEMALE-BANANA PLUG