- 您現在的位置：買賣IC網 > PDF目錄293745 > 1894-40KLF (INTEGRATED DEVICE TECHNOLOGY INC) DATACOM, INTERFACE CIRCUIT, QCC40 PDF資料下載
參數資料
| 型號： | 1894-40KLF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 網絡接口 |
| 英文描述： | DATACOM, INTERFACE CIRCUIT, QCC40 |
| 封裝： | 6 X 6 MM, ROHS COMPLIANT, QFN-40 |
| 文件頁數： | 1/52頁 |
| 文件大?。?/td> | 459K |
| 代理商： | 1894-40KLF |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
DATASHEET
10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE
ICS1894-40
IDT / ICS 10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE 1
ICS1894-40
REV C 092909
Description
The ICS1894-40 is a low-power, physical-layer device
(PHY) that supports the ISO/IEC 10Base-T and
100Base-TX Carrier-Sense Multiple Access/Collision
Detection (CSMA/CD) Ethernet standards, ISO/IEC
8802-3.
The ICS1894-40 is intended for MII, Node applications that
require the Auto-MDIX feature that automatically corrects
crossover errors in plant wiring.
The ICS1894-40 incorporates Digital-Signal Processing
(DSP) control in its Physical-Medium Dependent (PMD)
sub layer. As a result, it can transmit and receive data on
unshielded twisted-pair (UTP) category 5 cables with
attenuation in excess of 24 dB at 100MHz. With this
IDT-patented technology, the ICS1894-40 can virtually
eliminate errors from killer packets.
The ICS1894-40 provides a Serial-Management Interface
for exchanging command and status information with a
Station-Management (STA) entity. The ICS1894-40
Media-Dependent Interface (MDI) can be configured to
provide either half- or full-duplex operation at data rates of
10 Mb/s or 100Mb/s.
In addition, the ICS1894-40 includes a programmable
interupt output function. This function consists of a digital
output pin, an interrupt control register, a set of interrupt
status register bits and a corresponding set of interrupt
enable bits, and a pre-defined set of events which can be
assigned as one of the interrupt sources. The purpose of
this function is to notify the host of this PHY device when
certain event happens via interrupt (the logic level on
interrupt output pin going low or going high) instead of
polling by the host. The events that could be used to
generate interrupts are: receiver error, Jabber, page
received, parallel detect fault, link partner acknowledge, link
status change, auto-negotiation complete, remote fault,
collision, etc
Applications: NIC cards, PC motherboards, switches,
routers, DSL and cable modems, game machines, printers,
network connected appliances, and industrial equipment.
Features
Supports category 5 cables with attenuation in excess of
24dB at 100 MHz.
Single-chip, fully integrated PHY provides PCS, PMA,
PMD, and AUTONEG sub layers functions of IEEE
standard.
10Base-T and 100Base-TX IEEE 8802.3 compliant
MIIM (MDC/MDIO) management bus for PHY register
configuration
RMII interface support with external 50 MHz system clock
Single 3.3V power supply
Highly configurable, supports:
– Media Independent Interface (MII)
– Auto-Negotiation with Parallel detection
– Node applications, managed or unmanaged
– 10M or 100M full and half-duplex modes
– Loopback mode for Diagnostic Functions
Auto-MDI/MDIX crossover correction
Low-power CMOS (typically 300 mW)
Power-Down mode typically 21mW
Clock and crystal supported
Interrupt pin option
Fully integrated, DSP-based PMD includes:
– Adaptive equalization and baseline-wander
correction
– Transmit wave shaping and stream cipher
scrambler
– MLT-3 encoder and NRZ/NRZI encoder
Single power supply (3.3 V)
Built-in 1.8 V regulator for core
Available in 40-pin (5mm x 5mm) QFN package, Pb-free
Available in Industrial Temp and Lead Free
相關PDF資料 |
PDF描述 |
|---|---|
| 1894-40KLFT | DATACOM, INTERFACE CIRCUIT, QCC40 |
| 1895230000 | 15 A, STRIP TERMINAL BLOCK, 2 ROWS, 2 DECKS |
| 18F-08P-241 | 8 CONTACT(S), CABLE MOUNT, MINI DIN CONNECTOR, PLUG |
| 18F-08P-244 | 8 CONTACT(S), CABLE MOUNT, MINI DIN CONNECTOR, PLUG |
| 18F-08S-011 | 8 CONTACT(S), BOARD AND CABLE MOUNT, MINI DIN CONNECTOR, SOCKET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1894-40KLFT | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE |
| 1894410000 | 制造商:Weidmuller 功能描述:CONN TERM BLOCKS SKT 4 POS 5.08MM SCRW ST PNL MNT 10A - Bulk |
| 1894419 | 功能描述:可插拔接線端子 MSTBA 2.5/ 5-G- 5,08 BK AU RoHS:否 制造商:Phoenix Contact 產品:Plugs 系列:PTS 端接類型:Spring Cage 位置/觸點數量:5 線規量程:26-14 節距:5 mm 電流額定值:10 A 電壓額定值:250 V 安裝風格: 安裝角: 觸點電鍍: |
| 1894420000 | 制造商:Weidmuller 功能描述:CONN TERM BLOCKS SKT 5 POS 5.08MM SCRW ST PNL MNT 10A - Bulk |
| 1894430000 | 制造商:Weidmuller 功能描述:CONN TERM BLOCKS SKT 6 POS 5.08MM SCRW ST PNL MNT 10A - Bulk |
發布緊急采購，3分鐘左右您將得到回復。