參數資料
型號： SC16C752IB48,157
廠商： NXP Semiconductors
文件頁數： 7/47頁
文件大?。?/td> 0K
描述： IC DUAL UART 64BYTE 48LQFP
標準包裝： 1,250
通道數： 2，DUART
FIFO's： 64 字節
電源電壓： 2.5V，3.3V，5V
帶自動流量控制功能： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
安裝類型： 表面貼裝
封裝/外殼： 48-LQFP
供應商設備封裝： 48-LQFP（7x7）
包裝： 托盤
其它名稱： 935270055157
SC16C752IB48
SC16C752IB48-ND
Philips Semiconductors
SC16C752
Dual UART with 64-byte FIFO
Product data
Rev. 04 — 20 June 2003
15 of 47
9397 750 11635
Koninklijke Philips Electronics N.V. 2003. All rights reserved.
6.6.2
Block DMA transfers (DMA mode 1)
Figure 10 shows TXRDY and RXRDY in DMA mode 1.
Transmitter: TXRDY is active when there is a trigger level number of spaces
available. It becomes inactive when the FIFO is full.
Receiver: RXRDY becomes active when the trigger level has been reached, or when
a time-out interrupt occurs. It will go inactive when the FIFO is empty or an error in
the RX FIFO is agged by LSR[7].
6.7 Sleep mode
Sleep mode is an enhanced feature of the SC16C752 UART. It is enabled when
EFR[4], the enhanced functions bit, is set and when IER[4] is set. Sleep mode is
entered when:
The serial data input line, RX, is idle (see Section 6.8 “Break and time-out
The TX FIFO and TX shift register are empty.
There are no interrupts pending except THR and time-out interrupts.
Remark: Sleep mode will not be entered if there is data in the RX FIFO.
In sleep mode, the UART clock and baud rate clock are stopped. Since most registers
are clocked using these clocks, the power consumption is greatly reduced. The UART
will wake up when any change is detected on the RX line, when there is any change
in the state of the modem input pins, or if data is written to the TX FIFO.
Remark: Writing to the divisor latches, DLL and DLH, to set the baud clock, must not
be done during sleep mode. Therefore, it is advisable to disable sleep mode using
IER[4] before writing to DLL or DLH.
Fig 10. TXRDY and RXRDY in DMA mode 1.
TX
wrptr
TXRDY
FIFO FULL
TXRDY
RX
rdptr
FIFO EMPTY
RXRDY
AT LEAST ONE
LOCATION FILLED
RXRDY
002aaa234
TRIGGER
LEVEL
TRIGGER
LEVEL
相關PDF資料
PDF描述
ATMEGA1284P-AUR MCU AVR 128KB FLASH 20MHZ 44TQFP
ATMEGA1284P-MUR MCU AVR 128KB FLASH 20MHZ 44VQFN
AT89C51RB2-SLRUM MCU 8051 16K FLASH 5V 44-PLCC
AT89C51RB2-SLRUL MCU 8051 16K FLASH 3V 44-PLCC
MS27484E14B18S CONN PLUG 18POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
SC16C754 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Quad UART with 64-byte FIFO
SC16C754B 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V, 3.3 V and 2.5 V quad UART, 5 Mbit/s (max.) with 64-byte FIFOs
SC16C754BIA68 功能描述:UART 接口集成電路 16CB 2.5V-5V 4CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C754BIA68,512 功能描述:UART 接口集成電路 16CB 2.5V-5V 4CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C754BIA68,518 功能描述:UART 接口集成電路 4CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*