- 您現在的位置：買賣IC網 > PDF目錄371014 > MC145181 (Motorola, Inc.) Dual 550/60MHz PLL Frequency Synthesizers with DACs and Voltage Multipliers(帶DACs和電壓乘法器的雙550/60MHzPLL頻率合成器) PDF資料下載
參數資料
| 型號： | MC145181 |
| 廠商： | Motorola, Inc. |
| 英文描述： | Dual 550/60MHz PLL Frequency Synthesizers with DACs and Voltage Multipliers(帶DACs和電壓乘法器的雙550/60MHzPLL頻率合成器) |
| 中文描述： | 雙550/60MHz鎖相環頻率合成器的DAC和電壓倍增器（帶數模轉換器和電壓乘法器的雙550/60MHzPLL頻率合成器） |
| 文件頁數： | 1/71頁 |
| 文件大?。?/td> | 907K |
| 代理商： | MC145181 |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
Device
Main/Secondary
Loop
Maximum
Frequency
Package
SEMICONDUCTOR
TECHNICAL DATA
BiCMOS COMPONENT
FOR 2 OR 3 VOLT
SYSTEMS
ORDERING INFORMATION
MC145181FTAR2
550/60 MHz
LQFP–32
PLASTIC PACKAGE
CASE 873C
(LQFP–32, Tape & Reel Only)
VERY–SMALL 5 x 5 mm BODY
32
1
Order this document by MC145181/D
DEVELOPMENT SYSTEM
The MC145230EVK, which contains hardware and
software, is strongly recommended for system
development. (The user must provide the VCOs for
evaluating the MC145181.) The software supports
all features and modes of operation of the device. Up
to four boards or devices can be controlled and the
user is alerted to error conditions. The control
program may be used with any board based on the
MC145181, MC145225, or MC145230.
(Scale 2:1)
1
19
" %
"$ $! %#!
!"!
The MC145181 is a dual frequency synthesizer containing very–low
supply voltage circuitry. The device supports two independent loops with a
single input reference and operates down to 1.8 V. Phase noise reduction
circuitry is incorporated into the device.
The MC145181 operates up to 550 MHz on the main loop and up to
60 MHz on the secondary loop. The device has a 32/33 prescaler for the
main loop. Lock detection circuitry for both loops is multiplexed to a single
output.
Two 8–bit DACs are powered through a dedicated pin. The DAC supply
range is 1.8 to 3.6 V; this voltage may differ from the main supply.
An on–chip voltage multiplier supplies power to the phase/frequency
detectors. Thus, in a 2 V application, the detectors are supplied with 4 V
power. In 2.6 to 3.6 V applications, the multiplied voltage is regulated at
approximately 5 V. The current source/sink phase/frequency detector for the
main loop is designed to achieve faster lock times than a conventional
detector. Both high and low current outputs are available along with a timer,
double buffers, and a MOSFET switch to adjust the external low–pass filter
response.
There are several levels of standby which are controllable with a 1–byte
transfer through the serial port. Either of the PLLs and/or the reference
oscillator may be independently placed in the low–power standby state. In
addition, any of the phase/frequency detector outputs may be placed in the
floating state to facilitate modulation of the external VCOs. Either DAC may
be placed in standby via a 4–byte transfer.
The MC145181 facilitates designing the receiver’s first and second local
oscillators for ReFLEX
two–way paging applications. Also, the device
accommodates generation of the transmit carrier.
Operating Frequency
Main Loop: 100 to 550 MHz
Secondary Loop: 10 to 60 MHz
Operating Supply Voltage: 1.8 to 3.6 V
Nominal Supply Current, Both Loops Active: 3 mA
Maximum Standby Current, All Systems Shut Down: 10
μ
A
Phase Detector Output Current:
1.8 V Supply — PDout–Hi: 2.8 mA, PDout–Lo: 0.7 mA
2.5 V Supply — PDout–Hi: 4.4 mA, PDout–Lo: 1.1 mA
Two Independent 8–Bit DACs with Separate Supply Pin (Up to 3.6 V)
Lock Detect Output with Adjustable Lock Indication Window
Independent R Counters Allow Independent Step Sizes for Each Loop
Main Loop Divider Range: 992 to 262,143
Secondary Loop Divider Range: 7 to 8,191
Fractional Reference Counters Divider Range: 20 to 32,767.5
Auxiliary Reference Divider with Small–Signal Differential
Output — Ratios: 8, 10, 12.5
Three General–Purpose Outputs
Direct Interface to Motorola SPI Data Port Up to 10 Mbps
ReFLEX and BitGrabber are trademarks of Motorola, Inc.
Motorola, Inc. 1999
Rev 1
This document contains information on a new product. Specifications and information herein
are subject to change without notice.
相關PDF資料 |
PDF描述 |
|---|---|
| MC145193 | 1.1GHz PLL Frequency Synthesizer(1.1GHz PLL頻率合成器) |
| MC145202-1 | PLL Frequency Synthesizer(2.0GHz PLL頻率合成器) |
| MC145225 | Dual PLL Frequency Synthesizers With DACs and Voltage Multipliers(帶DACs和電壓乘法器的雙PLL頻率合成器) |
| MC145230 | Dual PLL Frequency Synthesizers With DACs and Voltage Multipliers(帶DACs和電壓乘法器的雙PLL頻率合成器) |
| MC14528BCL | Dual Monostable Multivibrator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC14518BCP | 功能描述:計數器移位寄存器 3-18V Dual BCD Up RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel |
| MC14518BCPG | 功能描述:計數器移位寄存器 3-18V Dual BCD Up RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel |
| MC14518BDW | 功能描述:計數器移位寄存器 3-18V Dual BCD Up RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel |
| MC14518BDWG | 功能描述:計數器移位寄存器 3-18V Dual BCD Up RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel |
| MC14518BDWR2 | 功能描述:計數器移位寄存器 3-18V Dual BCD Up RoHS:否 制造商:Texas Instruments 計數器類型: 計數順序:Serial to Serial/Parallel 電路數量:1 封裝 / 箱體:SOIC-20 Wide 邏輯系列: 邏輯類型: 輸入線路數量:1 輸出類型:Open Drain 傳播延遲時間:650 ns 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。