- 您現在的位置：買賣IC網 > PDF目錄67760 > M306H7MC-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | M306H7MC-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100 |
| 文件頁數： | 70/115頁 |
| 文件大?。?/td> | 3146K |
| 代理商： | M306H7MC-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁當前第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
Rev.2.10
Oct 25, 2006
Page 58 of 326
REJ03B0152-0210
M306H7MG-XXXFP/MC-XXXFP/FGFP
6. INTERRUPTS
6.17
NMI Interrupt
An NMI interrupt is generated when input on the NMI pin changes state from high to low. The NMI interrupt is a
non-maskable interrupt.
The input level of this NMI interrupt input pin can be read by accessing the P8 register’s P8_5 bit.
This pin cannot be used as an input port.
6.18
Address Match Interrupt
An address match interrupt request is generated immediately before executing the instruction at the address
indicated by the RMADi register (i = 0 to 3). Set the start address of any instruction in the RMADi register. Use the
AIER register’s AIER0 and AIER1 bits and the AIER2 register’s AIER20 and AIER21 bits to enable or disable the
interrupt. Note that the address match interrupt is unaffected by the I flag and IPL.
For address match interrupts, the value of the PC that is saved to the stack area varies depending on the instruction
being executed (refer to “Saving Registers”).
(The value of the PC that is saved to the stack area is not the correct return address.) Therefore, follow one of the
methods described below to return from the address match interrupt.
Rewrite the content of the stack and then use the REIT instruction to return.
Restore the stack to its previous state before the interrupt request was accepted by using the POP or similar other
instruction and then use a jump instruction to return.
Table 6.6 shows the value of the PC that is saved to the stack area when an address match interrupt request is
accepted.
Note that when using the external bus in 8 bits width, no address match interrupts can be used for externa areas.
Figure 6.11 shows the AIER, AIER2, and RMAD0 to RMAD3 registers.
Table 6.6
Instruction Just Before Execution and Address Stored in Stack When There Occurs
Interrupts
Table 6.7
Relationship Between Address Match Interrupt Sources and Associated Registers
16-bit op-code instruction
Instruction shown below among 8-bit operation code instructions
ADD.B:S
#IMM8,dest
SUB.B:S
#IMM8,dest
AND.B:S
#IMM8,dest
OR.B:S
#IMM8,dest
MOV.B:S
#IMM8,dest
STZ.B:S
#IMM8,dest
STNZ.B:S
#IMM8,dest
STZX.B:S
#IMM81,#IMM82,dest
CMP.B:S
#IMM8,dest
PUSHM
src
POPM dest
JMPS
#IMM8
JSRS
#IMM8
MOV.B:S
#IMM,dest (However, dest=A0 or A1)
Instructions other than the above
Instruction at the address indicated by the RMADi register
Value of the PC that is
saved to the stack area
The address
indicated by the
RMADi register +2
The address
indicated by the
RMADi register +1
Value of the PC that is saved to the stack area : Refer to “Saving Registers”.
Address match interrupt sources Address match interrupt enable bit
Address match interrupt register
Address match interrupt 0
AIER0
RMAD0
Address match interrupt 1
AIER1
RMAD1
Address match interrupt 2
AIER20
RMAD2
Address match interrupt 3
AIER21
RMAD3
相關PDF資料 |
PDF描述 |
|---|---|
| M306NMFHTGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128 |
| M306NMFJVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128 |
| M306NKFJVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| M306NKFHVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| M306NKFJTGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M306H7MG-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306K7F8LRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M306K9FCLRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M306K9T2-CPE | 功能描述:M-SUPPORT TOOL RoHS:否 類別:編程器，開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:* |
| M306KAFCLRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER Description |
發布緊急采購，3分鐘左右您將得到回復。