參數資料
型號: M306H7MC-XXXFP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
封裝: 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100
文件頁數: 41/115頁
文件大?。?/td> 3146K
代理商: M306H7MC-XXXFP
Rev.2.10
Oct 25, 2006
Page 31 of 326
REJ03B0152-0210
M306H7MG-XXXFP/MC-XXXFP/FGFP
4. CLOCK GENERATION CIRCUIT
4.1.2
Sub Clock
The sub clock is generated by the sub clock oscillation circuit. This clock is used as the clock source for the
CPU clock, as well as the timer A and timer B count sources. In addition, an fc clock with the same frequency
as that of the sub clock can be output from the CLKOUT pin.
The sub clock oscillator circuit is configured by connecting a crystal resonator between the XCIN and XCOUT
pins. The sub clock oscillator circuit contains a feedback resistor, which is disconnected from the oscillator
circuit during stop mode in order to reduce the amount of power consumed in the chip. The sub clock oscillator
circuit may also be configured by feeding an externally generated clock to the XCIN pin.
Figure 4.6 shows the examples of sub clock connection circuit.
When the level on the STARTB pin is “L ”, the sub clock is turned off after reset. At this time, the feedback
resistor is disconnected from the oscillator circuit.
To use the sub clock for the CPU clock, set the CM07 bit of CM0 register to “1 ” (sub clock) after the sub clock
becomes oscillating stably.
When a STARTB pin is “H ”, the sub clock (XCIN) divided by 8 becomes the CPU clock after reset (the main
clock stops). When you use a main clock after this, please shift according to the procedure shown in Fig. 4.7.
During stop mode, all clocks including the sub clock are turned off. Refer to “power control”.
Figure 4.6
Examples of Sub Clock Connection Circuit
Microcomputer
(Built-in feedback resistor)
XCIN
XCOUT
Externally derived clock
Open
Vcc
Vss
Note: Insert a damping resistor if required. The resistance will vary depending on the oscillator and the oscillation drive
capacity setting. Use the value recommended by the maker of the oscillator.
When the oscillation drive capacity is set to low, check that oscillation is stable. Also, if the oscillator manufacturer's
data sheet specifies that a feedback resistor be added external to the chip, insert a feedback resistor between XCIN
and XCOUT following the instruction.
Microcomputer
(Built-in feedback resistor)
XCIN
XCOUT
(Note)
CCIN
CCOUT
RCd
相關PDF資料
PDF描述
M306NMFHTGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128
M306NMFJVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128
M306NKFJVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
M306NKFHVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
M306NKFJTGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M306H7MG-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER
M306K7F8LRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M306K9FCLRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M306K9T2-CPE 功能描述:M-SUPPORT TOOL RoHS:否 類別:編程器,開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:*
M306KAFCLRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER Description