參數資料
型號: M306H7MC-XXXFP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
封裝: 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100
文件頁數: 40/115頁
文件大?。?/td> 3146K
代理商: M306H7MC-XXXFP
Rev.2.10
Oct 25, 2006
Page 30 of 326
REJ03B0152-0210
M306H7MG-XXXFP/MC-XXXFP/FGFP
4. CLOCK GENERATION CIRCUIT
4.1
Oscillator Circuit
The following describes the clocks generated by the clock generation circuit.
Two oscillation circuits are built in the clock generating circuit, and a main clock or a sub clock can be chosen as a
CPU clock by setup of the STARTB pin after reset.
4.1.1
Main Clock
This clock is used as the clock source for the CPU and peripheral function clocks. The main clock oscillator
circuit is configured by connecting a resonator between the XIN and XOUT pins. The main clock oscillator
circuit contains a feedback resistor, which is disconnected from the oscillator circuit during stop mode in order
to reduce the amount of power consumed in the chip. The main clock oscillator circuit may also be configured
by feeding an externally generated clock to the XIN pin. Figure 4.5 shows the examples of main clock
connection circuit.
When the level on the STARTB pin is “L”, the main clock divided by 8 is selected for the CPU clock (Sub
clock turned off) after reset.
The power consumption in the chip can be reduced by setting the CM05 bit of CM0 register to “1” (main clock
oscillator circuit turned off) after switching the clock source for the CPU clock to a sub clock. In this case,
XOUT goes “H”. Furthermore, because the internal feedback resistor remains on, XIN is pulled “H” to XOUT via
the feedback resistor. Note that if an externally generated clock is fed into the XIN pin, the main clock cannot be
turned off by setting the CM05 bit to “1” without selecting sub clock for the CPU clock. If necessary, use an
external circuit to turn off the clock.
During stop mode, all clocks including the main clock are turned off. Refer to “power control”.
Figure 4.5
Examples of Main Clock Connection Circuit
Microcomputer
(Built-in feedback resistor)
XIN
XOUT
Externally derived clock
Open
Vcc
Vss
Microcomputer
(Built-in feedback resistor)
XIN
XOUT
Rd
CIN
COUT
(Note)
Note: Insert a damping resistor if required. The resistance will vary depending on the oscillator and the oscillation drive
capacity setting. Use the value recommended by the maker of the oscillator.
When the oscillation drive capacity is set to low, check that oscillation is stable. Also, if the oscillator manufacturer's
data sheet specifies that a feedback resistor be added external to the chip, insert a feedback resistor between XIN
and XOUT following the instruction.
相關PDF資料
PDF描述
M306NMFHTGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128
M306NMFJVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128
M306NKFJVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
M306NKFHVGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
M306NKFJTGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M306H7MG-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER
M306K7F8LRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M306K9FCLRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M306K9T2-CPE 功能描述:M-SUPPORT TOOL RoHS:否 類別:編程器,開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:*
M306KAFCLRP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER Description