- 您現在的位置：買賣IC網 > PDF目錄67760 > M306H7MC-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | M306H7MC-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100 |
| 文件頁數： | 63/115頁 |
| 文件大小： | 3146K |
| 代理商： | M306H7MC-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁當前第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
Rev.2.10
Oct 25, 2006
Page 51 of 326
REJ03B0152-0210
M306H7MG-XXXFP/MC-XXXFP/FGFP
6. INTERRUPTS
6.9
Interrupt Sequence
An interrupt sequence — what are performed over a period from the instant an interrupt is accepted to the instant
the interrupt routine is executed — is described here.
If an interrupt occurs during execution of an instruction, the processor determines its priority when the execution of
the instruction is completed, and transfers control to the interrupt sequence from the next cycle. If an interrupt
occurs during execution of either the SMOVB, SMOVF, SSTR or RMPA instruction, the processor temporarily
suspends the instruction being executed, and transfers control to the interrupt sequence.
The CPU behavior during the interrupt sequence is described below. Figure 6.4 shows time required for executing
the interrupt sequence.
(1) The CPU gets interrupt information (interrupt number and interrupt request priority level) by reading the
address 0000016. Then it clears the IR bit for the corresponding interrupt to “0” (interrupt not requested).
(2) The FLG register immediately before entering the interrupt sequence is saved to the CPU’s internal temporary
register(Note 1).
(3) The I, D and U flags in the FLG register become as follows:
The I flag is cleared to “0” (interrupts disabled).
The D flag is cleared to “0” (single-step interrupt disabled).
The U flag is cleared to “0” (ISP selected).
However, the U flag does not change state if an INT instruction for software interrupt Nos. 32 to 63 is executed.
(4) The CPU’s internal temporary register (Note 1) is saved to the stack.
(5) The PC is saved to the stack.
(6) The interrupt priority level of the accepted interrupt is set in the IPL.
(7) The start address of the relevant interrupt routine set in the interrupt vector is stored in the PC.
After the interrupt sequence is completed, the processor resumes executing instructions from the start address of
the interrupt routine.
Note: This register cannot be used by user.
Figure 6.4
Time Required for Executing Interrupt Sequence
Indeterminate (Note 1)
1
2
34
56
78
9
10
11
12
13
14
15
16
17
18
Indeterminate (Note 1)
SP-2
contents
SP-4
contents
vec
contents
vec+2
contents
Interrupt
information
Address
000016
Indeterminate (Note 1)
SP-2
SP-4
vec
vec+2
PC
CPU clock
Address bus
Data bus
WR
RD
Note 1 : The indeterminate state depends on the instruction queue buffer. A read cycle occurs when
the instruction queue buffer is ready to accept instructions.
Note 2 : The WR signal timing shown here is for the case where the stack is located in the internal RAM.
(Note 2)
相關PDF資料 |
PDF描述 |
|---|---|
| M306NMFHTGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128 |
| M306NMFJVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP128 |
| M306NKFJVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| M306NKFHVGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| M306NKFJTGP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M306H7MG-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306K7F8LRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M306K9FCLRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M306K9T2-CPE | 功能描述:M-SUPPORT TOOL RoHS:否 類別:編程器，開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:* |
| M306KAFCLRP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER Description |
發布緊急采購，3分鐘左右您將得到回復。