參數資料
型號： ISP1583ET1,118
廠商： ST-ERICSSON
元件分類： 總線控制器
英文描述： UNIVERSAL SERIAL BUS CONTROLLER, PBGA64
封裝： 4 X 4 MM, 0.80 MM HEIGHT, LEAD FREE, PLASTIC, SOT969-1,TFBGA-64
文件頁數： 18/100頁
文件大小： 508K
代理商： ISP1583ET1,118
ISP1583_7
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 07 — 22 September 2008
23 of 99
NXP Semiconductors
ISP1583
Hi-Speed USB peripheral controller
8.16 Power supply
The ISP1583 can be powered by 3.3 V
± 0.3 V, and from 1.65 V to 3.6 V at the interface.
For details, see Figure 12. If the ISP1583 is powered by VCC(3V3) = 3.3 V, an integrated
3.3 V-to-1.8 V voltage regulator provides a 1.8 V supply voltage for the internal logic.
In sharing mode (that is, when VCC(3V3) is not present and VCC(I/O) is present), all I/O pins
are input type, the interrupt pin is connected to ground, and the suspend pin is connected
to VCC(I/O). See Table 7.
Table 8 shows power modes in which the ISP1583 can be operated.
[1]
The power supply to the IC (VCC(3V3)) is 3.3 V. Therefore, if the application is bus-powered, a 3.3 V regulator
needs to be used.
[2]
VCC(I/O) can range from 1.65 V to 3.6 V. If the application is bus-powered, a voltage regulator must be used.
(1) At the VCC input (3.3 V) to the USB controller, if the ripple voltage is less than 20 mV, then 4.7 F
standard electrolytic or tantalum capacitors (tested ESR up to 10
) should be OK at the VCC1V8
output. If the ripple voltage at the input is higher than 20 mV, then use 4.7
F LOW ESR capacitors
(ESR from 0.2
to 2 ) at the VCC1V8 output. This is to improve the high-speed signal quality at
the USB side.
The gure shows the ISP1583BS pinout. For the ISP1583ET, ISP1583ET1 and ISP1583ET2
ballouts, see Table 3.
Fig 12. ISP1583 with a 3.3 V supply
Table 8.
Power modes
VCC(3V3)
VCC(I/O)
Power mode
VBUS[1]
VBUS[2]
bus-powered
System-powered
system-powered
self-powered
VBUS[1]
system-powered
power-sharing (hybrid)
004aaa271
61
VCC(I/O)
ISP1583
3.3 V
± 0.3 V
VCC(I/O)
VCC(3V3)
26
41
VCC(I/O)
VCC1V8
54
56
4.7 F(1)
0.1 F
0.01 F
0.1 F
0.01 F
0.1 F
0.01 F
0.1 F
0.01 F
0.1 F
32
0.1 F
1.65 V to 3.6 V
VCC1V8
相關PDF資料
PDF描述
ISP1583BS,551 UNIVERSAL SERIAL BUS CONTROLLER, PQCC64
ISP1583ET2 UNIVERSAL SERIAL BUS CONTROLLER, PBGA64
ISP1761ET,518 UNIVERSAL SERIAL BUS CONTROLLER, PBGA128
ISP1761BE,518 UNIVERSAL SERIAL BUS CONTROLLER, PQFP128
ISP1761BE,551 UNIVERSAL SERIAL BUS CONTROLLER, PQFP128
相關代理商/技術參數
參數描述
ISP1583ET1-T 功能描述:外圍驅動器與原件 - PCI USB 2.0 SM FTPRINT RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
ISP1583ET1TM 制造商:STMicroelectronics 功能描述:
ISP1583ET2 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Hi-Speed USB peripheral controller
ISP1583ET2,518 功能描述:外圍驅動器與原件 - PCI USB 2.0 DEVICE RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
ISP1583ET2-T 功能描述:外圍驅動器與原件 - PCI USB 2.0 DEVICE RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*