- 您現在的位置：買賣IC網 > PDF目錄370311 > GCIXF440AC Controller Miscellaneous - Datasheet Reference PDF資料下載
參數資料
| 型號： | GCIXF440AC |
| 英文描述： | Controller Miscellaneous - Datasheet Reference |
| 中文描述： | 控制器雜項-數據表參考 |
| 文件頁數： | 80/128頁 |
| 文件大?。?/td> | 1262K |
| 代理商： | GCIXF440AC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁當前第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
Intel
IXF1002 Dual Port Gigabit Ethernet Controller
80
Datasheet
6.4
MAC Transmit Operation
This section describes the transmit operation in detail, as supported by the IXF1002. Transmit
activities are registered into the network management registers, which are accessible through the
CPU port.
6.4.1
Transmit Initiation
After the transmit FIFO is adequately filled up to the programmed threshold level
(TX_TSHD<TSD>), or after there is a full frame loaded into the transmit FIFO, the IXF1002 starts
to encapsulate the frame. The transmit encapsulation is performed by the transmit controller, which
delays the actual transmission of the data onto the network until it has been idle for a minimum
interpacket gap (IPG) time.
6.4.2
Inter Packet Gap
Actual transmission of the data onto the network occurs 96-bit time period (by default) after the
completion of the last transmission. The interpacket gap time can be changed through the
IPG_VAL register. In accordance with the standard, the IXF1002 begins to measure the IPG in
full-duplex mode from TEN deassertion.
6.4.3
Frame Encapsulation
The transmit data frame encapsulation stream includes the appending of the 56 preamble bits and the
8 bits of SFD to the basic frame beginning, and the FCS to the basic frame end. The basic frame
loaded from the bus includes the destination address field, the source address field, the type/length
field, and the data field. If the data field length is shorter than 46 bytes and pad appending is not
disabled (TX_RX_PARAM<PADD> or TX_RX_PARAM<CRCD>), the IXF1002 pads the basic
frame with the pattern 00 for up to 46 bytes. At the end of the frame, the IXF1002 appends the FCS
field if CRC appending is not disabled (TX_RX_PARAM<CRCD>). If the txasis signal is asserted at
the beginning of the packet load, the IXF1002 ignores the programmed mode and transmits the frame
without the padding and the FCS field.
In the GMII mode, the transmit enable signal (ten{i}) is asserted together with the first preamble
byte transmission and is deasserted with the last CRC byte transmission.
6.4.4
Terminating Transmission
A specific frame transmission is terminated under any of the following conditions:
Normal
The frame has been transmitted successfully. After the last byte is serialized, the pad and CRC
are optionally appended and transmitted, thus concluding frame transmission.
CRC error
The txerr signal was asserted during packet loading. The IXF1002 infects the CRC it is
building and sends a bad CRC onto the network. A transmit error will be generated as well
(terr assertion in GMII mode, or symbol error in GPCS mode).
相關PDF資料 |
PDF描述 |
|---|---|
| GCIXF440ACT | Controller Miscellaneous - Datasheet Reference |
| GCIXP1250-166 | Microprocessor |
| GCIXP1250-200 | Microprocessor |
| GCIXP1250-232 | Microprocessor |
| GCK101 | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GCIXF440ACT | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intel 功能描述: |
| GCIXP1200EB | 功能描述:IC NETWRK PROCESSR 200MHZ 432BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:60 系列:SCC 處理器類型:Z380 特點:全靜電 Z380 CPU 速度:20MHz 電壓:5V 安裝類型:表面貼裝 封裝/外殼:144-LQFP 供應商設備封裝:144-LQFP 包裝:托盤 |
| GCIXP1200FC | 功能描述:IC NETWRK PROCESSR 232MHZ 432BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:60 系列:SCC 處理器類型:Z380 特點:全靜電 Z380 CPU 速度:20MHz 電壓:5V 安裝類型:表面貼裝 封裝/外殼:144-LQFP 供應商設備封裝:144-LQFP 包裝:托盤 |
| GCIXP1200GA | 功能描述:IC MPU NETWORK 166MHZ 432-BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:60 系列:SCC 處理器類型:Z380 特點:全靜電 Z380 CPU 速度:20MHz 電壓:5V 安裝類型:表面貼裝 封裝/外殼:144-LQFP 供應商設備封裝:144-LQFP 包裝:托盤 |
| GCIXP1200GB | 功能描述:IC MPU NETWORK 200MHZ 432-BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:40 系列:MPC83xx 處理器類型:32-位 MPC83xx PowerQUICC II Pro 特點:- 速度:267MHz 電壓:0.95 V ~ 1.05 V 安裝類型:表面貼裝 封裝/外殼:516-BBGA 裸露焊盤 供應商設備封裝:516-PBGAPGE（27x27） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。