- 您現在的位置：買賣IC網 > PDF目錄1917 > DSP56301VF100 (Freescale Semiconductor)IC DSP 24BIT FIXED-POINT 252-BGA PDF資料下載
參數資料
| 型號： | DSP56301VF100 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 9/124頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DSP 24BIT FIXED-POINT 252-BGA |
| 產品變化通告： | DSP56301 Discontinuation 12/Nov/2009 |
| 標準包裝： | 60 |
| 系列： | DSP563xx |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 100MHz |
| 非易失內存： | ROM（9 kB） |
| 芯片上RAM： | 24kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 3.30V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 252-BGA |
| 供應商設備封裝： | 252-MAPBGA（21x21） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
DSP56301 Technical Data, Rev. 10
4-4
Freescale Semiconductor
Design Considerations
Equation 5:
Where:
ItypF2
=
current at F2
ItypF1
=
current at F1
F2
=
high frequency (any specified operating frequency)
F1
=
low frequency (any specified operating frequency lower than F2)
Note:
F1 should be significantly less than F2. For example, F2 could be 66 MHz and F1 could be 33 MHz. The
degree of difference between F1 and F2 determines the amount of precision with which the current rating
can be determined for an application.
4.4 PLL Performance Issues
The following explanations should be considered as general observations on expected PLL behavior. There is no
test that replicates these exact numbers. These observations were measured on a limited number of parts and were
not verified over the entire temperature and voltage ranges.
4.4.1
Phase Skew Performance
The phase skew of the PLL is defined as the time difference between the falling edges of EXTAL and CLKOUT
for a given capacitive load on CLKOUT, over the entire process, temperature and voltage ranges. As defined in
Figure 2-2, External Clock Timing, on page -5 for input frequencies greater than 15 MHz and the MF
≤ 4, this
skew is greater than or equal to 0.0 ns and less than 1.8 ns; otherwise, this skew is not guaranteed. However, for MF
< 10 and input frequencies greater than 10 MHz, this skew is between
1.4 ns and +3.2 ns.
4.4.2
Phase Jitter Performance
The phase jitter of the PLL is defined as the variations in the skew between the falling edges of EXTAL and
CLKOUT for a given device in specific temperature, voltage, input frequency, MF, and capacitive load on
CLKOUT. These variations are a result of the PLL locking mechanism. For input frequencies greater than 15 MHz
and MF
≤ 4, this jitter is less than ±0.6 ns; otherwise, this jitter is not guaranteed. However, for MF < 10 and input
frequencies greater than 10 MHz, this jitter is less than
±2 ns.
4.4.3
Frequency Jitter Performance
The frequency jitter of the PLL is defined as the variation of the frequency of CLKOUT. For small MF (MF < 10)
this jitter is smaller than 0.5 per cent. For mid-range MF (10 < MF < 500) this jitter is between 0.5 per cent and
approximately 2 per cent. For large MF (MF > 500), the frequency jitter is 2–3 per cent.
4.5 Input (EXTAL) Jitter Requirements
The allowed jitter on the frequency of EXTAL is 0.5 percent. If the rate of change of the frequency of EXTAL is slow
(that is, it does not jump between the minimum and maximum values in one cycle) or the frequency of the jitter is
fast (that is, it does not stay at an extreme value for a long time), then the allowed jitter can be 2 percent. The phase
and frequency jitter performance results are valid only if the input jitter is less than the prescribed values.
I MIPS
I MHz
I
typF2
I
typF1
–
() F2 F1
–
()
==
相關PDF資料 |
PDF描述 |
|---|---|
| DSP56303VL100B1 | IC DSP 24BIT 100MHZ 196-BGA |
| DSP56311VF150B1 | IC DSP 24BIT 150MHZ 196-BGA |
| DSP56321VF200R2 | IC DSP 24BIT 200MHZ 196-BGA |
| DSP56852VFE | IC DSP 16BIT 120MHZ 81-MAPBGA |
| DSP56854FGE | IC DSP 16BIT 120MHZ 128-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP56301VF80 | 功能描述:數字信號處理器和控制器 - DSP, DSC MAP DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56301VF80B1 | 功能描述:數字信號處理器和控制器 - DSP, DSC DSP56301VF80B1 RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56301VL100 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:24-Bit Digital Signal Processor |
| DSP56301VL80 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:24-Bit Digital Signal Processor |
| DSP56302 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:DSP56301 Digital Signal Processor |
發布緊急采購，3分鐘左右您將得到回復。