參數資料
型號: AM79C961AVCW
廠商: ADVANCED MICRO DEVICES INC
元件分類: 微控制器/微處理器
英文描述: PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA
中文描述: 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP144
封裝: TQFP-144
文件頁數: 51/206頁
文件大?。?/td> 1507K
代理商: AM79C961AVCW
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁
Am79C961A
51
If a card was driving the bus or if the card was in high
impedance and did not sense another card driving the
bus, then it should prepare for the next pair of I/O
reads. The card shifts the serial identifier by one bit and
uses the shifted bit to decide its response. The above
sequence is repeated for the entire 72-bit serial
identifier.
At the end of this process, one card remains. This card
is assigned a handle referred to as the
Card Select
Number
(CSN) that will be used later to select the card.
Cards which have been assigned a CSN will not partic-
ipate in subsequent iterations of the isolation protocol.
Cards must be assigned a CSN before they will
respond to the other commands defined in the
specification.
It should be noted that the protocol permits the 8-bit
checksum to be stored in non-volatile memory on the
card or generated by the on-card logic in real-time. The
same LFSR algorithm described in the initiation key
section of the Plug and Play specification is used in the
checksum generation.
Software Protocol
The Plug and Play software sends the initiation key to
all Plug and Play cards to place them into configuration
mode. The software is then ready to perform the isola-
tion protocol.
The Plug and Play software generates 72 pairs of l/O
read cycles from the READ_DATA port. The software
checks the data returned from each pair of I/O reads for
the 0x55 and 0xAA driven by the hardware. If both 0x55
and 0xAA are read back, then the software assumes
that the hardware had a
1" bit in that position. All other
results are assumed to be a
0.
During the first 64 bits, software generates a checksum
using the received data. The checksum is compared
with the checksum read back in the last 8 bits of the
sequence.
There are two other special considerations for the soft-
ware protocol. During an iteration, it is possible that the
0x55 and 0xAA combination is never detected. It is also
possible that the checksum does not match If either of
these cases occur on the first iteration, it must be
assumed that the READ_DATA port is in conflict. If a
conflict is detected, then the READ_DATA port is
relocated. The above process is repeated until a non-
conflicting location for the READ_DATA port is found.
The entire range between 0x203 and 0x3FF is avail-
able, however in practice it is expected that only a few
locations will be tried before software determines that
no Plug and Play cards are present.
During subsequent iterations, the occurrence of either
of these two special cases should be interpreted as the
absence of any further Plug and Play cards (i.e. the last
card was found in the previous iteration). This
terminates the isolation protocol.
Note:
The software must delay 1 ms prior to starting
the first pair of isolation reads, and must
wait 250
μ
sec
between each subsequent pair of isolation reads. This
delay gives the ISA card time to access information
from possibly very slow storage devices.
Plug and Play Card Control Registers
The state transitions and card control commands for
the PCnet-ISA II controller are shown in the following
figure.
相關PDF資料
PDF描述
AM79C961AVIW PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA
Am79C965A PCnet?-32 Single-Chip 32-Bit Ethernet Controller
AM79C970AKCW PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970AKC PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970A PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
相關代理商/技術參數
參數描述
AM79C961AVI 制造商:Rochester Electronics LLC 功能描述:
AM79C961AVI/W 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller
AM79C961AVI\\W 制造商:Rochester Electronics LLC 功能描述:
AM79C961AVI\W 制造商:Rochester Electronics LLC 功能描述:
AM79C961AVIW 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA