- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C961AKIW (ADVANCED MICRO DEVICES INC) PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA PDF資料下載
參數資料
| 型號： | AM79C961AKIW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| 中文描述： | 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP132 |
| 封裝： | PLASTIC, QFP-132 |
| 文件頁數： | 94/206頁 |
| 文件大?。?/td> | 1507K |
| 代理商： | AM79C961AKIW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁當前第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁
94
Am79C961A
other option requires an external device (such as a
‘
loopback plug
’
) to loop the data back to the chip, a
function normally not available on a 10BASE-T
network.
The PCnet-ISA II chip has two dedicated FCS genera-
tors, eliminating the traditional LANCE limitations on
loopback FCS operation. The receive FCS generation
logic is always enabled. The transmit FCS generation
logic can be disabled (to emulate LANCE type loop-
back operation) by setting the DXMTFCS bit in the
Mode register (CSR15). In this configuration, software
must generate the FCS and append the four FCS bytes
to the transmit frame data.
The loopback facilities of the MAC Engine allow full
operation to be verified without disturbance to the net-
work. Loopback operation is also affected by the state
of the Loopback Control bits (LOOP, MENDECL, and
INTL) in CSR15. This affects whether the internal
MENDEC is considered part of the internal or external
loop- backpath.
The receive FCS generation logic in the PCnet-ISA II
chip is used for multicast address detection. Since this
FCS logic is always enabled, there are no restrictions
to the use of multicast addressing while in loopback
mode.
When performing an internal loopback, no frame will be
transmitted to the network. However, when the PC-
net-ISA II controller is configured for internal loopback
the receiver will not be able to detect network traffic.
External loopback tests will transmit frames onto the
network if the AUI port is selected, and the PCnet-ISA
II controller will receive network traffic while configured
for external loopback when the AUI port is selected.
Runt Packet Accept is automatically enabled when any
loopback mode is invoked.
Loopback mode can be performed with any frame size.
Runt Packet Accept is internally enabled (RPA bit in
CSR124 is not affected) when any loopback mode is
invoked. This is to be backwards compatible to the
LANCE (Am7990) software.
LEDs
The PCnet-ISA II controller
’
s LED control logic allows
programming of the status signals, which are displayed
on 3 LED outputs. One LED (LED0) is dedicated to dis-
playing 10BASE-T Link Status. The status signals
available are Collision, Jabber, Receive, Receive Polar-
ity, Transmit, Receive Address Match, and Full Duplex
Link Status. If more than one status signal is enabled,
they are ORed together. An optional pulse stretcher is
available for each programmable output. This allows
emulation of the TPEX (Am79C98) and TPEX
+
(Am79C100) LED outputs.
Each status signal is ANDed with its corresponding
enable signal. The enabled status signals run to a com-
mon OR gate:
The output from the OR gate is run through a pulse
stretcher, which consists of a 3-bit shift register clocked
at 38 Hz. The data input of the shift register is at logic
0. The OR gate output asynchronously sets all three
bits of the shift register when its output goes active. The
output of the shift register controls the associated LEDx
pin. Thus, the pulse stretcher provides an LED output
of 52 ms to 78 ms.
Signal
Behavior
COL
Active during collision activity on the network
FDLS
Active when Full Duplex operation is enabled
and functioning on the selected network port
JAB
Active when the PCnet-ISA II is jabbering on
the network
LNKST
Active during Link OK Not active during Link
Down
RCV
Active while receiving data
RVPOL
Active during receive polarity is OK Not active
during reverse receive polarity
RCVADDM
Active during Receive with Address Match
XMT
Active while transmitting data
AND
FDLS
FDLSE
AND
RCVM
RCVM E
AND
XMT
XMT E
AND
RVPOL
RVPOL E
AND
RCV
RCV E
AND
JAB
JAB E
AND
COL
COL E
OR
To
Pulse
Stretcher
AND
RCVADDM
RCVADDE
19364B-22
LED Control Logic
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C961AVCW | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961AVIW | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| Am79C965A | PCnet?-32 Single-Chip 32-Bit Ethernet Controller |
| AM79C970AKCW | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C961APDLUTS | 制造商:Advanced Micro Devices 功能描述: |
| AM79C961AVC | 制造商:Rochester Electronics LLC 功能描述: 制造商:Advanced Micro Devices 功能描述:LAN Node Controller, 144 Pin, TQFP |
| AM79C961AVC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
| AM79C961AVC\\W | 制造商:Rochester Electronics LLC 功能描述: |
| AM79C961AVC\W | 制造商:Rochester Electronics LLC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。