- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C961AKIW (ADVANCED MICRO DEVICES INC) PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA PDF資料下載
參數資料
| 型號： | AM79C961AKIW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| 中文描述： | 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP132 |
| 封裝： | PLASTIC, QFP-132 |
| 文件頁數： | 29/206頁 |
| 文件大小： | 1507K |
| 代理商： | AM79C961AKIW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁
Am79C961A
29
SBHE
System Bus High Enable
This signal indicates the HIGH byte of the system data
bus is to be used. There is a weak pull-up resistor on
this pin. If the PCnet-ISA II controller is installed in an
8-bit only system like the PC/XT, SBHE will always be
HIGH and the PCnet-ISA II controller will perform only
8-bit operations. There must be at least one LOW going
edge on this signal before the PCnet-ISA II controller
will perform 16-bit operations.
SD0-15
System Data Bus
This bus is used to transfer data to and from the PC-
net-ISA II controller to system resources via the ISA
data bus. SD0-15 is driven by the PCnet-ISA II
controller when performing slave read operations.
Input
Input/Output
Likewise, the data on SD0-15 is latched by the PC-
net-ISA II controller when performing slave write
operations.
Board Interface
APCS/IRQ15
Address PROM Chip Select
This signal is asserted when the external Address
PROM is read. When an I/O read operation is per-
formed on the first 16 bytes in the PCnet-ISA II
controller
’
s I/O space, APCS is asserted. The outputs
of the external Address PROM drive the PROM Data
Bus. The PCnet-ISA II controller buffers the contents of
the PROM data bus and drives them on the lower eight
bits of the System Data Bus. IOCS16 is not asserted
during this cycle.
BPAM
Boot PROM Address Match
This pin indicates a Boot PROM access cycle. If no
Boot PROM is installed, this pin has a default value of
HIGH and thus may be left connected to V
DD
.
BPCS
Boot PROM Chip Select
This signal is asserted when the Boot PROM is read. If
BPAM is active and MEMR is active, the BPCS signal
will be asserted. The outputs of the external Boot
PROM drive the PROM Data Bus. The PCnet-ISA II
controller buffers the contents of the PROM data bus
and drives them on the System Data Bus. IOCS16 is
not asserted during this cycle. If 16-bit cycles are
performed, it is the responsibility of external logic to
assert MEMCS16 signal.
Output
Input
Output
DXCVR/EAR
Disable Transceiver/
External Address Reject
This pin disables the transceiver. The DXCVR output is
configured in the initialization sequence. A high level
indicates the Twisted Pair Interface is active and the
AUI is inactive, or SLEEP mode has been entered. A
low level indicates the AUI is active and the Twisted Pair
interface is inactive.
Input/Output
If EADI mode is selected, this pin becomes the EAR
input.
The incoming frame will be checked against the inter-
nally active address detection mechanisms and the
result of this check will be OR
’
d with the value on the
EAR pin. The EAR pin is defined as REJECT. (See the
EADI section for details regarding the function and tim-
ing of this signal).
LED0-3
LED Drivers
These pins sink 12 mA each for driving LEDs. Their
meaning is software configurable (see section
The ISA
Bus Configuration Registers
) and they are active LOW.
Output
When EADI mode is selected, the pins named LED1,
LED2, and LED3 change in function while LED0
continues to indicate 10BASE-T Link Status. The
DXCVR input becomes the EAR input.
PRAB0-15
Private Address Bus
The Private Address Bus is the address bus used to
drive the Address PROM, Remote Boot PROM, and
SRAM.
PRDB3-7
Private Data Bus
This is the data bus for the static RAM, the Boot PROM,
and the Address PROM.
PRDB2/EEDO
Private Data Bus Bit 2/Data Out
A multifunction pin which serves as PRDB2 of the
private data bus and, when ISACSR3 bit 4 is set,
changes to become DATA OUT from the EEPROM.
Input/Output
Input/Output
Input/Output
LED
EADI Function
1
SF/BD
2
SRD
3
SRDCLK
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C961AVCW | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961AVIW | PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| Am79C965A | PCnet?-32 Single-Chip 32-Bit Ethernet Controller |
| AM79C970AKCW | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C961APDLUTS | 制造商:Advanced Micro Devices 功能描述: |
| AM79C961AVC | 制造商:Rochester Electronics LLC 功能描述: 制造商:Advanced Micro Devices 功能描述:LAN Node Controller, 144 Pin, TQFP |
| AM79C961AVC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
| AM79C961AVC\\W | 制造商:Rochester Electronics LLC 功能描述: |
| AM79C961AVC\W | 制造商:Rochester Electronics LLC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。