參數資料
型號： 16F630
廠商： Microchip Technology Inc.
英文描述： 14-Pin FLASH-Based 8-Bit CMOS Microcontrollers
中文描述： 14引腳基于閃存的8位CMOS微控制器
文件頁數： 61/132頁
文件大?。?/td> 2651K
代理商： 16F630
2003 Microchip Technology Inc.
DS40039C-page 59
PIC16F630/676
9.3.5
BROWN-OUT DETECT (BOD)
The PIC16F630/676 members have on-chip Brown-out
Detect circuitry. A configuration bit, BODEN, can
disable (if clear/programmed) or enable (if set) the
Brown-out Detect circuitry. If V
DD
falls below V
BOD
for
greater than parameter (T
BOD
) in Table 12-4 (see
Section 12.0), the Brown-out situation will reset the
device. This will occur regardless of V
DD
slew-rate. A
RESET is not guaranteed to occur if V
DD
falls below
V
BOD
for less than parameter (T
BOD
).
On any RESET (Power-on, Brown-out Detect,
Watchdog, etc.), the chip will remain in RESET until
V
DD
rises above BV
DD
(see Figure 9-6). The Power-up
Timer will now be invoked, if enabled, and will keep the
chip in RESET an additional 72 ms.
If V
DD
drops below BV
DD
while the Power-up Timer is
running, the chip will go back into a Brown-out Detect
and the Power-up Timer will be re-initialized. Once V
DD
rises above BV
DD
, the Power-up Timer will execute a
72 ms RESET.
FIGURE 9-6:
BROWN-OUT SITUATIONS
9.3.6
TIME-OUT SEQUENCE
On power-up, the time-out sequence is as follows: first,
PWRT time-out is invoked after POR has expired.
Then, OST is activated. The total time-out will vary
based on oscillator configuration and PWRTE bit
status. For example, in EC mode with PWRTE bit
erased (PWRT disabled), there will be no time-out at
all. Figure 9-7, Figure 9-8 and Figure 9-9 depict time-
out sequences.
Since the time-outs occur from the POR pulse, if MCLR
is kept low long enough, the time-outs will expire. Then
bringing MCLR high will begin execution immediately
(see Figure 9-8). This is useful for testing purposes or
to synchronize more than one PIC16F630/676 device
operating in parallel.
Table 9-6 shows the RESET conditions for some
special registers, while Table 9-7 shows the RESET
conditions for all the registers.
9.3.7
POWER CONTROL (PCON) STATUS
REGISTER
The power CONTROL/STATUS register, PCON
(address 8Eh) has two bits.
Bit0 is BOD (Brown-out). BOD is unknown on Power-
on Reset. It must then be set by the user and checked
on subsequent RESETS to see if BOD = 0, indicating
that a brown-out has occurred. The BOD STATUS bit is
a don’t care and is not necessarily predictable if the
brown-out circuit is disabled (by setting BODEN bit = 0
in the Configuration word).
Bit1 is POR (Power-on Reset). It is a ‘0’ on Power-on
Reset and unaffected otherwise. The user must write a
‘1’ to this bit following a Power-on Reset. On a
subsequent RESET, if POR is ‘0’, it will indicate that a
Power-on Reset must have occurred (i.e., V
DD
may
have gone too low).
Note:
A Brown-out Detect does not enable the
Power-up Timer if the PWRTE bit in the
configuration word is set.
72 ms
(1)
V
BOD
V
DD
Internal
RESET
V
BOD
V
DD
Internal
RESET
72 ms
(1)
<72 ms
72 ms
(1)
V
BOD
V
DD
Internal
RESET
Note
1:
72 ms delay only if PWRTE bit is programmed to ‘0’.
相關PDF資料
PDF描述
16F84 CAT 5E CROSSOVER, BLUE 15 FT PATCH CABLE
16F84A CAT 5E CROSSOVER PATCH CORD CABLE BLUE 20 FT
16F871 CAT 5E CROSSOVER PATCH CORD CABLE GREEN 6 FT
16F872 CAT 5E CROSSOVER PATCH CORD CABLE GREEN 10 FT
16F876A 28/40-pin Enhanced FLASH Microcontrollers
相關代理商/技術參數
參數描述
16F684-I 制造商:Microchip Technology Inc 功能描述:
16F6H 制造商:EDAL 制造商全稱:EDAL 功能描述:Silicon High Voltage Assembly
16F6H1 制造商:EDAL 制造商全稱:EDAL 功能描述:Silicon High Voltage Assembly
16F7674 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMD TWEEZER HEAD
16F7676 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CLIP KABELKIT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*