參數資料
型號: 16F630
廠商: Microchip Technology Inc.
英文描述: 14-Pin FLASH-Based 8-Bit CMOS Microcontrollers
中文描述: 14引腳基于閃存的8位CMOS微控制器
文件頁數: 60/132頁
文件大?。?/td> 2651K
代理商: 16F630
PIC16F630/676
DS40039C-page 58
2003 Microchip Technology Inc.
9.3.1
MCLR
PIC16F630/676 devices have a noise filter in the
MCLR Reset path. The filter will detect and ignore
small pulses.
It should be noted that a WDT Reset does not drive
MCLR pin low.
The behavior of the ESD protection on the MCLR pin
has been altered from previous devices of this family.
Voltages applied to the pin that exceed its specification
can result in both MCLR Resets and excessive current
beyond the device specification during the ESD event.
For this reason, Microchip recommends that the MCLR
pin no longer be tied directly to V
DD
. The use of an RC
network, as shown in Figure 9-5, is suggested.
An internal MCLR option is enabled by setting the
MCLRE bit in the configuration word. When enabled,
MCLR is internally tied to V
DD
. No internal pull-up
option is available for the MCLR pin.
FIGURE 9-5:
RECOMMENDED
MCLR
CIRCUIT
9.3.2
POWER-ON RESET (POR)
The on-chip POR circuit holds the chip in RESET until
V
DD
has reached a high enough level for proper
operation. To take advantage of the POR, simply tie the
MCLR pin through a resistor to V
DD
. This will eliminate
external RC components usually needed to create
Power-on Reset. A maximum rise time for V
DD
is
required. See Electrical Specifications for details (see
Section 12.0). If the BOD is enabled, the maximum rise
time specification does not apply. The BOD circuitry will
keep the device in RESET until V
DD
reaches V
BOD
(see
Section 9.3.5).
When the device starts normal operation (exits the
RESET condition), device operating parameters (i.e.,
voltage, frequency, temperature, etc.) must be met to
ensure operation. If these conditions are not met, the
device must be held in RESET until the operating
conditions are met.
For additional information, refer to Application Note
AN607 “Power-up Trouble Shooting”
.
9.3.3
POWER-UP TIMER (PWRT)
The Power-up Timer provides a fixed 72 ms (nominal)
time-out on power-up only, from POR or Brown-out
Detect. The Power-up Timer operates on an internal
RC oscillator. The chip is kept in RESET as long as
PWRT is active. The PWRT delay allows the V
DD
to
rise to an acceptable level. A configuration bit, PWRTE
can disable (if set) or enable (if cleared or
programmed) the Power-up Timer. The Power-up
Timer should always be enabled when Brown-out
Detect is enabled.
The Power-up Time delay will vary from chip to chip
and due to:
V
DD
variation
Temperature variation
Process variation.
See DC parameters for details (Section 12.0).
9.3.4
OSCILLATOR START-UP TIMER
(OST)
The Oscillator Start-up Timer (OST) provides a 1024
oscillator cycle (from OSC1 input) delay after the
PWRT delay is over. This ensures that the crystal
oscillator or resonator has started and stabilized.
The OST time-out is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
Note:
The POR circuit does not produce an inter-
nal RESET when V
DD
declines.
V
DD
PIC16F630/676
MCLR
R1
1 k
(
or greater
)
C1
0.1
μ
f
(optional, not critical)
相關PDF資料
PDF描述
16F84 CAT 5E CROSSOVER, BLUE 15 FT PATCH CABLE
16F84A CAT 5E CROSSOVER PATCH CORD CABLE BLUE 20 FT
16F871 CAT 5E CROSSOVER PATCH CORD CABLE GREEN 6 FT
16F872 CAT 5E CROSSOVER PATCH CORD CABLE GREEN 10 FT
16F876A 28/40-pin Enhanced FLASH Microcontrollers
相關代理商/技術參數
參數描述
16F684-I 制造商:Microchip Technology Inc 功能描述:
16F6H 制造商:EDAL 制造商全稱:EDAL 功能描述:Silicon High Voltage Assembly
16F6H1 制造商:EDAL 制造商全稱:EDAL 功能描述:Silicon High Voltage Assembly
16F7674 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMD TWEEZER HEAD
16F7676 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CLIP KABELKIT