- 您現在的位置：買賣IC網 > PDF目錄231501 > W972GG8JB-25 (WINBOND ELECTRONICS CORP) 256M X 8 DDR DRAM, 0.4 ns, PBGA60 PDF資料下載
參數資料
| 型號： | W972GG8JB-25 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | DRAM |
| 英文描述： | 256M X 8 DDR DRAM, 0.4 ns, PBGA60 |
| 封裝： | 11 X 11.50 MM, ROHS COMPLIANT, WBGA-60 |
| 文件頁數： | 22/86頁 |
| 文件大小： | 1466K |
| 代理商： | W972GG8JB-25 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
W972GG8JB
Publication Release Date: Feb. 18, 2011
- 29 -
Revision A02
Table 5
– Precharge & Auto-precharge clarifications
From
Command
To Command
Minimum Delay between “From
Command” to “To Command”
Unit
Notes
Read
Precharge (to same Bank as Read)
AL + BL/2 + max(RTP, 2) - 2
clks
1, 2
Precharge All
AL + BL/2 + max(RTP, 2) - 2
clks
1, 2
Read w/AP
Precharge (to same Bank as Read w/AP)
AL + BL/2 + max(RTP, 2) - 2
clks
1, 2
Precharge All
AL + BL/2 + max(RTP, 2) - 2
clks
1, 2
Write
Precharge (to same Bank as Write)
WL + BL/2 + tWR
clks
2
Precharge All
WL + BL/2 + tWR
clks
2
Write w/AP
Precharge (to same Bank as Write w/AP)
WL + BL/2 + WR
clks
2
Precharge All
WL + BL/2 + WR
clks
2
Precharge
Precharge (to same Bank as Precharge)
1
clks
2
Precharge All
1
clks
2
Precharge
All
Precharge
1
clks
2
Precharge All
1
clks
2
Notes:
1. RTP[cycles] = RU{ tRTP[nS] / tCK(avg)[nS] }, where RU stands for round up.
2. For a given bank, the precharge period should be counted from the latest precharge command, either one bank precharge or
precharge all, issued to that bank. The precharge period is satisfied after tRPall (= tRP + 1 x tCK) depending on the latest
precharge command issued to that bank.
7.8
Refresh Operation
DDR2 SDRAM requires a refresh of all rows in any rolling 64 ms interval. The necessary refresh can
be generated in one of two ways: by explicit Auto Refresh commands or by an internally timed Self
Refresh mode.
Self Refresh mode enters issuing the Self Refresh command (CKE asserted "LOW") while all banks
are in the idle state. The device is in Self Refresh mode for as long as CKE held "LOW". In the case of
8192 burst Auto Refresh commands, 8192 burst Auto Refresh commands must be performed within
7.8 S before entering and after exiting the Self Refresh mode. In the case of distributed Auto Refresh
commands, distributed auto refresh commands must be issued every 7.8 S and the last distributed
Auto Refresh commands must be performed within 7.8 S before entering the self refresh mode. After
exiting from the Self Refresh mode, the refresh operation must be performed within 7.8 S. In Self
Refresh mode, all input/output buffers are disable, resulting in lower power dissipation (except CKE
buffer). (Example timing waveform refer to 10.29 Self Refresh diagram in Chapter 10)
7.9
Power Down Mode
Power-down is synchronously entered when CKE is registered LOW, along with NOP or Deselect
command. CKE is not allowed to go LOW while mode register or extended mode register command
time, or read or write operation is in progress. CKE is allowed to go LOW while any other operation
such as row activation, Precharge or Auto-precharge or Auto Refresh is in progress, but power down
IDD specification will not be applied until finishing those operations.
The DLL should be in a locked state when power-down is entered. Otherwise DLL should be reset
after exiting power-down mode for proper read operation.
相關PDF資料 |
PDF描述 |
|---|---|
| WF512K32-150CJC | 512K X 32 FLASH 5V PROM MODULE, 150 ns, CQCC68 |
| W73B586A-09L | 32K X 18 CACHE SRAM, 9 ns, PQCC52 |
| WS512K32-100G4TM | 2M X 8 MULTI DEVICE SRAM MODULE, 100 ns, CQFP68 |
| WS512K32-35G4M | 2M X 8 MULTI DEVICE SRAM MODULE, 35 ns, CQFP68 |
| WS512K32-35G4Q | 2M X 8 MULTI DEVICE SRAM MODULE, 35 ns, CQFP68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W972GG8JB-25I | 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 2.5NS 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 2.5NS 80WBGA |
| W972GG8JB-3 | 制造商:Winbond Electronics Corp 功能描述:DRAM Chip DDR2 SDRAM 2G-Bit 256Mx8 1.8V 60-Pin WBGA 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 3NS |
| W9751G6IB-25 | 功能描述:IC DDR2-800 SDRAM 512MB 84-WBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1,000 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (512 x 8) 速度:400kHz 接口:I²C，2 線串口 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.173"，4.40mm 寬） 供應商設備封裝:8-MFP 包裝:帶卷 (TR) |
| W9751G6JB | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8M ? 4 BANKS ? 16 BIT DDR2 SDRAM |
| W9751G6JB-25 | 制造商:Winbond Electronics Corp 功能描述:512GB DDRII |
發布緊急采購，3分鐘左右您將得到回復。