參數資料
型號: TDA8035HN/C1
廠商: NXP SEMICONDUCTORS
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PQCC32
封裝: 5 X 5 MM, 0.85 MM HEIGHT, PLASTIC, SOT617-7, HVQFN-32
文件頁數: 7/32頁
文件大?。?/td> 908K
代理商: TDA8035HN/C1
TDA8035HN
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 1.0 — 19 April 2011
15 of 32
NXP Semiconductors
TDA8035HN
Smart card interface
8.10 Fault detection
The following fault conditions are monitored by the circuit:
1. Short-circuit or high current on VCC
2. Card removal during transaction
3. VDDP or VDD(INTF) or Vreg dropping
4. Overheating.
There are two different cases (see Figure 10 on page 16):
1. CMDVCCN High: (outside a card session) then, OFFN is Low if the card is not in the
reader, and High if the card is in the reader. A supply voltage drop on VDDP is detected
by the supply supervisor, generates an internal power-on reset pulse, but does not act
upon OFFN. The card is not powered-up, so no short-circuit or overheating is
detected.
2. CMDVCCN Low: (within a card session) then, OFFN falls Low in any of the
aforementioned cases. As soon as the fault is detected, an emergency deactivation is
automatically performed. When the system controller sets CMDVCCN back to High, it
may sense OFFN again after complete deactivation sequence in order to distinguish
between a hardware problem or a card extraction (OFFN will then go back High if the
card is still present).
Depending on the type of card presence switch within the connector (normally close or
normally open), and on the mechanical characteristics of the switch, a bouncing may
occur on PRESN signal at card insertion or withdrawal. Consequently, a debounce feature
of approximately 4.05 ms (tdeb = 1280 × 1/(fosc(int)_Low) is integrated in the device.
Figure 11 on page 16 When the card is inserted, OFFN goes High only at the end of the
debouncing time.
When the card is extracted, an automatic deactivation sequence of the card is performed
on the first True/False transition on PRESN, and OFFN goes Low .
相關PDF資料
PDF描述
TDA8779H-T SPECIALTY ANALOG CIRCUIT, PQFP44
TEA1103N 0.014 A BATTERY CHARGE CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDIP20
TEA1103TD 0.014 A BATTERY CHARGE CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO20
TEA1610T/N5,118 SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PDSO16
TEA1733LT/N1 SWITCHING CONTROLLER, 71 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
TDA8037T/C1J 制造商:NXP Semiconductors 功能描述:TDA8037T/SO28/REEL13//C1 - Tape and Reel
TDA8037TT/C1J 制造商:NXP Semiconductors 功能描述:TDA8037TT/TSSOP16/REEL13//C1 - Tape and Reel
TDA8040T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Quadrature demodulator
TDA8041H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Quadrature demodulator controller
TDA8041HB-S 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ASK/FSK Demodulator