參數資料
型號： SP37E760-MC
廠商： STANDARD MICROSYSTEMS CORP
元件分類： 外設及接口
英文描述： 3.3 V I/O CONTROLLER FOR EMBEDDED APPLICATIONS
中文描述： MULTIFUNCTION PERIPHERAL, PQFP100
封裝： QFP-100
文件頁數： 25/78頁
文件大?。?/td> 510K
代理商： SP37E760-MC
SMSC DS – SP37E760
Page 25
Rev. 04/13/2001
BIT 2
BIT 3
BIT 4
BIT 5
BIT 6
BIT 7
Interrupt ID Bit Interrupt ID Bit
(Note 5)
0
0
FIFOs Enabled
(Note 5)
FIFOs
Enabled (Note
5)
RCVR Trigger
MSB
XMIT FIFO
Reset
DMA Mode
Select (Note
6)
Parity Enable
(PEN)
Reserved
Reserved
RCVR Trigger
LSB
Number of
Stop Bits
(STB)
OUT1
(Note 3)
Parity Error
(PE)
Even Parity
Select (EPS)
Stick Parity Set Break
Divisor Latch
Access Bit
(DLAB)
0
OUT2
(Note 3)
Framing Error
(FE)
Loop
0
0
Break
Interrupt (BI)
Transmitter
Holding
Register
(THRE)
Data Set
Ready
(DSR)
Bit 5
Bit 5
Bit 13
Transmitter
Empty (TEMT)
(Note 2)
Error in
RCVR FIFO
(Note 5)
Trailing Edge
Ring Indicator
(TERI)
Bit 2
Bit 2
Bit 10
Delta Data
Carrier Detect
(DDCD)
Bit 3
Bit 3
Bit 11
Clear to
Send (CTS)
Ring Indicator
(RI)
Data Carrier
Detect (DCD)
Bit 4
Bit 4
Bit 12
Bit 6
Bit 6
Bit 14
Bit 7
Bit 7
Bit 15
Note 3:
This bit no longer has a pin associated with it.
Note 4:
When operating in the XT mode, this register is not available.
Note 5:
These bits are always zero in the non-FIFO mode.
Note 6:
Writing a one to this bit has no effect. DMA modes are not supported in this chip.
4.4 Notes On Serial Port FIFO Mode Operation
4.4.1
The RCVR FIFO will hold up to 16 bytes regardless of which trigger level is selected.
GENERAL
4.4.2
The Tx portion of the UART transmits data through TXD as soon as the CPU loads a byte into the Tx FIFO.
The
UART will prevent loads to the Tx FIFO if it currently holds 16 characters.
Loading to the Tx FIFO will again be
enabled as soon as the next character is transferred to the Tx shift register. These capabilities account for the largely
autonomous operation of the Tx.
The UART starts the above operations typically with a Tx interrupt. The chip issues a Tx interrupt whenever the Tx
FIFO is empty and the Tx interrupt is enabled, except in the following instance. Assume that the Tx FIFO is empty
and the CPU starts to load it. When the first byte enters the FIFO the Tx FIFO empty interrupt will transition from
active to inactive. Depending on the execution speed of the service routine software, the UART may be able to
transfer this byte from the FIFO to the shift register before the CPU loads another byte. If this happens, the Tx FIFO
will be empty again and typically the UART’s interrupt line would transition to the active state. This could cause a
system with an interrupt control unit to record a Tx FIFO empty condition, even though the CPU is currently servicing
that interrupt.
Therefore, after the first byte has been loaded into the FIFO the UART will wait one serial
character transmission time before issuing a new Tx FIFO empty interrupt.
This one character Tx interrupt delay will remain active until at least two bytes have been loaded into the
FIFO, concurrently. When the Tx FIFO empties after this condition, the Tx interrupt will be activated without
a one character delay.
Rx support functions and operation are quite different from those described for the transmitter. The Rx FIFO receives
data until the number of bytes in the FIFO equals the selected interrupt trigger level. At that time if Rx interrupts are
enabled, the UART will issue an interrupt to the CPU. The Rx FIFO will continue to store bytes until it holds 16 of
them. It will not accept any more data when it is full. Any more data entering the Rx shift register will set the Overrun
TX AND RX FIFO OPERATION
相關PDF資料
PDF描述
SP8720 ECL two-modulus divider, with ECL10K compatible outputs
SP8720ADG ECL two-modulus divider, with ECL10K compatible outputs
SP8720BDG ECL two-modulus divider, with ECL10K compatible outputs
SPF5001 Surface-mount 4-circuit Low-side Switch Array
SPF5002 Surface-mount 4-circuit Low-side Switch Array
相關代理商/技術參數
參數描述
SP37E760-MD 功能描述:輸入/輸出控制器接口集成電路 Super I/O Controller RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray
SP37E760-MT 功能描述:輸入/輸出控制器接口集成電路 Super I/O Controller RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray
SP37R0FL 制造商:TE Connectivity 功能描述:SP3 7R0 1% LOOSEFixed Resistor
SP38 制造商:BES 功能描述:3/8" x 6" Spade Bit 制造商:BES MANUFACTURING 功能描述:SPADE BIT 3/8 X 6 INCH
SP380 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NOR GATES
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*