參數資料
型號： SDA9401
廠商： Electronic Theatre Controls, Inc.
英文描述： Scan Rate Converter using Embedded DRAM Technology Units
中文描述： 掃描頻率轉換器采用嵌入式DRAM技術股
文件頁數： 19/69頁
文件大?。?/td> 1142K
代理商： SDA9401
Micronas
19
Preliminary Data Sheet
SDA 9401
The three different “multi picture modes” can be selected by the parameter MULTIPIC. MULTIPIC=0
defines normal operation without compression. The table below explains the performed
compressions depending on the “multi picture mode” and the corresponding aspect ratio of the
display.
Input write parameter: MULTIPIC
To get a “multi picture display” the following executions must be performed:
Entering a “multi picture mode” is defined by transmitting a value MULTIPIC>0. This value of
MULTIPIC must not be equal to the previous value of MULTIPIC. During the following two fields the
memory will be completely filled with a constant colour defined by the parameters YBORDER,
UBORDER, VBORDER. This colour is identical to the background and the borders of the multi
picture display. The same procedure is performed when the “multi picture mode” changes from a
value MULTIPIC>0 to another value MULTIPIC>0. Beginning with the following field the
compressed input picture is written at the position PICPOS addressed via I2C-bus. The user has to
address all possible positions PICPOS one after the other to build a complete multi picture display.
In sequence, the background colour is replaced by the small pictures. The not overwritten areas of
the background colour form the borders of the multi picture display.
The pictures can be taken from the same source (’Shots of a Sequence’) or from different sources
(’Tuner Scanning’). The actual addressed picture is moving until “Freeze mode” is activated.
Before entering “multi picture mode” the “H-and-V-freerunning mode” (see also
chapter Output sync
controller (OSC)
on page 29) should be activated via the I2C bus bits HOUTFR and VOUTFR,
especially when “Tuner Scanning” will be performed. The “H-and-V-freerunning mode” avoids
synchronization problems of the display during changing the tuner channel.
The values of ALPFIP (Active Lines Per Field Input, see also
chapter Input sync controller (ISC)
on
page 9), and ALPFOP (Active Lines Per Field Output, see also
chapter Output sync controller
(OSC)
on page 29) must be set to 144 or 121, respectively. Only these standard signals
corresponding to PAL and NTSC systems are supported. A mixture of PAL and NTSC signals is
also possible.
Input write parameter
MULTIPIC (1Bh)
Horizontal compression
Vertical compression
Aspect ratio of the display
00 (Multi Picture Off)
01 (fourfold)
10 (twelvefold)
11 (sixteenfold)
normal operation, no compression
2 : 1
4 : 1
4 : 1
2 : 1
3 : 1
4 : 1
4 : 3
16 : 9
4 : 3
Parameter
Subaddress
Description
MULTIPIC
PICPOS
1Bh
1Bh
Defines the multi picture modes
Position of the picture in the multi picture mode (only
valid for MULTIPIC>0)
Y background value
U background value
V background value
YBORDER
UBORDER
VBORDER
17h
18h
18h
相關PDF資料
PDF描述
SDB0530 Schottky Barrier Diode
SDB0540 Schottky Barrier Diode
SDB10100PI High Voltage Schottky Rectifier
SDB10150PI High Voltage Schottky Rectifier
SDB1040PH Schottky Rectifier
相關代理商/技術參數
參數描述
SDA9410-B13 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter using Embedded DRAM Technology Units
SDA9415-B13 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter
SDA9488X 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Cost-effective Picture-In-Picture ICs
SDA9489X 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PIP IV Advanced SOPHISTICUS High-End Picture-In-Picture ICs
SDA-95009-F 制造商:MOLEX 制造商全稱:Molex Electronics Ltd. 功能描述:Modular Jack, Right Angle, 6/4, Panel Stops
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*