- 您現在的位置：買賣IC網 > PDF目錄374647 > S2065 (Applied Micro Circuits Corp.) Quad Serial Backplane Device with Dual I/O(帶雙傳送接收串行I/O的四收發器) PDF資料下載
參數資料
| 型號： | S2065 |
| 廠商： | Applied Micro Circuits Corp. |
| 英文描述： | Quad Serial Backplane Device with Dual I/O(帶雙傳送接收串行I/O的四收發器) |
| 中文描述： | 四串行設備，配有雙背板的I / O（帶雙傳送接收串行的I / O的四收發器） |
| 文件頁數： | 13/37頁 |
| 文件大?。?/td> | 381K |
| 代理商： | S2065 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
13
S2065
QUAD SERIAL BACKPLANE DEVICE WITH DUAL I/O
October 13, 2000 / Revision G
Figure 8. Channel Lock State Machine
Loss of Channel Lock will be reported as indicated in
Figure 9 and Table 8 by a 1-0-1 on the ERR, EOF,
and KFLAG signals, respectively. This is during the
“No Sync” state. The status lines will reflect the status
of the individual channels and the device will respond
to appropriate channel locking sequences and
deskew as necessary. Persistence of 1-0-1 status on
any channel is indicative of CRU lock failure, most
likely resulting from loss of receiver input signal. The
device will then respond to the channel locking se-
quence.
When operating in the Channel Lock Mode, the
TCLK[B-D] inputs must be tied low.
Channel Locking/Re-locking Procedure
The Channel locking/relocking procedures are sum-
marized below. Following these procedures will in-
sure proper CHANNEL LOCK operation of the
device. When powered up, the S2065 will lock to the
received data within approximately 2500 bit times.
The CRU must report lock for approximately 32,000
REFCLK periods (320
μ
s) before channel locking is
enabled.
1. Ensure that the S2065 is in the “No Sync” state.
This can be accomplished by resetting the device
by toggling SOFD low, or by de-asserting the
channel lock for several clock periods and then
re-asserting.
2. Transmit the appropriate synchronization se-
quence. Four K28.5 characters or the 16 word
SYNC sequence can be used to de-skew the
DOUT FIFOs. The 16 word SYNC character can
be generated by asserting SOFx=1 and
KGENx=1.
3. Wait for “channel lock detected” as defined by
Table 8.
The S2065 will enter the “No Sync” state if: any CRU
loses lock, if the CH_LOCK signal is de-asserted, if
four or more consecutive decoder errors are ob-
served, or if the decoder error rate exceeds 50% in a
block of 16 bytes, or if SOFD is low. If desired, the
CRU lock status of each channel can be checked by
de-asserting CH_LOCK and confirming that “Loss of
Sync” status (Table 8) is not reported by any chan-
nel. To reacquire Sync after moving to the “No Sync”
state, repeat steps 2 and 3 above.
RE-SYNC
NO SYNC
IN SYNC
All four channels in Re-Sync with
valid data within deskew window
Errored codeword or
valid data outside deskew window
or SOFD = LOW
CRU Loss of Lock or
four sequential decoding errors or
decoding error rate > 50% (block 16)
RESET
ACQUIRING SYNC
One K28.5 Detected
≥
4 K28.5 Detected
Errored codeword or <4 K28.5
or SOFD = LOW
SOFD = LOW or
相關PDF資料 |
PDF描述 |
|---|---|
| S2066 | Quad GigaBit Ethernet Transceiver(四千兆位以太網收發器) |
| S2067 | Dual Serial Backplane Transceiver with Dual I/O(帶雙傳送接收串行I/O的雙收發器) |
| S2068 | Dual GigaBit Ethernet Transceiver(雙千兆位以太網收發器) |
| S2070 | Fibre Channel and GigaBit Ethernet Transceiver(帶片上鎖相環的光纖通道/千兆位以太網收發器) |
| S2071 | Four Port Bypass for FC-AL(用于FC-AL的四端口旁路電路) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S2065A | 制造商:AppliedMicro 功能描述:Backplane Transceiver 208-Pin TBGA |
| S2065J | 功能描述:SCR 65A 200V RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| S2065J | 制造商:Littelfuse 功能描述:Thyristor Thyristor/Triac Type:SCR |
| S2065J_ | 功能描述:SCR - Use 576-S2065J RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| S2065JTP | 功能描述:SCR SCR 200V 65A Iso RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。