參數資料
型號: M37920F8CGP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
封裝: 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100
文件頁數: 144/155頁
文件大小: 1274K
代理商: M37920F8CGP
89
M37920F8CGP, M37920F8CHP, M37920FCCGP
M37920FCCHP, M37920FGCGP, M37920FGCHP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
MITSUBISHI MICROCOMPUTERS
In the array chain transfer, the transfer parameters are first read from
the transfer parameter memory and then written into the SAR, DAR,
and TCR. This operations state is called the “array state”. Figures 83
and 84 show timing diagram examples in the array chain transfer
mode (burst transfer mode). The DMA controller outputs the start ad-
dress of the transfer parameter memory to the address bus, and se-
quentially stores the read data into the SAR, DAR, and TCR.
When the transfer parameters for 1 block are completely stored, the
contents of the TBC are decremented by 1, and then, the first DMA
transfer starts in accordance with the stored parameters. These op-
erations for storing parameters are called “array state”.
In contrast to the array state, the state in which DMA transfer is ac-
tive is called “transfer state”. In the transfer state, the same opera-
tions are performed as in the single transfer mode. Each time when
1-transfer-unit data has been transferred, the contents of the TCR
are decremented by 1 in 8-bit transfer or by 2 in 16-bit transfer. Even
when the contents of the TCR become 0, the DMA request bit and
DMA enable bit are not cleared to “0” and the array state of the next
block starts.
When the contents of the TBC are 0 at the start of the array state,
the entire transfer operation is considered to be completed, and “L”
level is output into pin TC to clear the DMA request bit and DMA en-
able bit and terminate array chain transfer. At the same time, the in-
terrupt request bit of the DMA interrupt control register is set to “1”.
In the cycle steal transfer at the array chain transfer mode, one array
state and transfer cycle of 1 transfer unit are made by one DMA re-
quest.
相關PDF資料
PDF描述
M38039MFL-XXXHP 8-BIT, MROM, 16.8 MHz, MICROCONTROLLER, PQFP64
M38039MFL-XXXSP 8-BIT, MROM, 16.8 MHz, MICROCONTROLLER, PDIP64
M38039MFL-XXXWG 8-BIT, MROM, 16.8 MHz, MICROCONTROLLER, PBGA64
M38039FFLHP 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PQFP64
M38039FFLWG 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PBGA64
相關代理商/技術參數
參數描述
M37920FCCGP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
M37920FCCHP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
M37920FGCGP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
M37920FGCHP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
M37920S4CGP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER