參數資料
型號: M37640E8FP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 51/96頁
文件大?。?/td> 1477K
代理商: M37640E8FP
55
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
The USB Power Management Register, shown in
Figure 1.54, is used for power management in the
USB FCU.
USB Suspend Detection Flag (SUSPEND)
When the USB FCU does not detect any bus activ-
ity on D+/D- for at least 3ms, it sets the Suspend
Detection Flag (SUSPEND) and generates an inter-
rupt. This bit is cleared when signaling (from the
host) is detected on D+/D- [which sets the Resume
Detection Flag (RESUME) and generates an inter-
rupt] or the Remote Wake-up Bit (WAKEUP) is set
and then cleared by the CPU. If the USB clock was
disabled during the suspend state, the SUSPEND
bit is not cleared until after the USB clock is re-en-
abled.
USB Resume Detection Flag (RESUME)
When the USB FCU is in the suspend state and de-
tects signaling on D+/D- (from the host), it sets the
Resume Detection Flag (RESUME) and generates
an interrupt. The CPU writes a “1” to INST14 (bit 6
of USB Interrupt Status Register 2) to clear this
flag.
USB Remote Wake-up Bit (WAKEUP)
The CPU writes a “1” to the WAKEUP bit for remote
wake-up. While this bit is set, and the USB FCU is
in suspend mode, it will generate resume signaling
to the host. The CPU must keep this bit set for a
minimum of 10ms and a maximum of 15ms before
writing a “0” to this bit.
Fig. 1.54. USB Power Management Register (USBPM)
SUSPEND USB Suspend Detection Flag (bit 0) (Read only)
0: No USB suspend detected
1: Idle state for greater than 3ms (USB suspend) detected
RESUME
USB Resume Detection Flag (bit 1)(Read only)
0: No USB resume signaling detected
1: USB resume signaling detected
WAKEUP
USB Remote Wake-up Bit (bit 2)
0: End remote resume signaling
1: Send remote resume signaling (only if SUSPEND = “1”)
Bit7:3
Reserved (Read/Write “0”)
Reser ved
WAKEUP RESUME
MSB
7
LSB
0
Address: 0051
16
Access: R/W
Reset: 00
16
Reser ved
SUSPEND
相關PDF資料
PDF描述
M37643M8-XXXHP 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37643F8HP 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80
M37700E2AFS 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC80
M37700E2AXXXFP 16-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80
M37701E2-XXXSP 16-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP64
相關代理商/技術參數
參數描述
M37640E8FS 功能描述:EPROM MCU/8BIT CMOS EMULATION CH RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230,RCB231,RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
M37640M4T 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-111FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-126FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE CHIP 8 BIT CMOS MICROCOMPUTER