- 您現在的位置：買賣IC網 > PDF目錄69014 > M37640E8FP 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M37640E8FP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 43/96頁 |
| 文件大?。?/td> | 1477K |
| 代理商： | M37640E8FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
48
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
1.19.7 UART Address Mode
The UART address mode is intended for use in a
multi-receiver environment where an address is sent
before each message to designate which UART or
UARTs are to wake-up and receive the message. An
address is identified by the MSB of the incoming data
byte being a “1”. The bit is “0” for non-address data.
UART address mode can be used in either 8-bit or 9-
bit character length mode. The character length is
chosen by writing the appropriate values to the UART
Character Length Selection Bits (LE1,0).
UART address mode is enabled by setting the UART
Address Mode Enable Bit (AME) to “1”. When UART
address mode is enabled, the MSB of a newly re-
ceived byte of data (that is either 8 or 9 bits in length)
is examined if a valid stop bit is detected and a parity
error has not occurred (if parity is enabled). If the MSB
is “1”, then the receive buffer full interrupt and flag are
set and AME is automatically cleared, disabling UART
address mode. If the MSB is “0”, then the receive
buffer full interrupt is not set. However, the RBF flag is
still set for this case. If a valid stop bit is not detected
or a parity error has occurred, neither the receive buffer
full flag nor interrupt is set and the MSB of the data is
not examined. Instead, either the framing error or par-
ity error flag is set, the error sum flag is set, and the
error sum interrupt is set.
While in UART address mode, the generation of over-
run errors is disabled after the first byte of data is
received. Therefore, when non-address data is re-
ceived without errors while in the UART address mode,
it is not necessary to read the UART receive buffer
prior to the reception of the next byte of data. Also, if
a framing or parity error occurs while in UART address
mode, it is not necessary to read the UxSTS prior to
the reception of the next byte of data. However, an
overrun error will occur if an address byte is received
and the UART receive buffer is not read before a new
byte of data is received. This is the case because the
UART address mode was automatically disabled when
the address byte was received. Also, an overrun error
will occur for the first byte received after UART address
mode is enabled if the preceding byte received did not
generate an error and the UART receive buffer was not
read, or the preceding byte did generate an error and
UxSTS was not read.
相關PDF資料 |
PDF描述 |
|---|---|
| M37643M8-XXXHP | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37643F8HP | 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37700E2AFS | 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC80 |
| M37700E2AXXXFP | 16-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80 |
| M37701E2-XXXSP | 16-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37640E8FS | 功能描述:EPROM MCU/8BIT CMOS EMULATION CH RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE |
| M37640M4T | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-111FP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-126FP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE CHIP 8 BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。