- 您現在的位置：買賣IC網 > PDF目錄69014 > M37640E8FP 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M37640E8FP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 26/96頁 |
| 文件大?。?/td> | 1477K |
| 代理商： | M37640E8FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
32
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
Pulse Output Mode
Count Source:
F/n (where n is 8, 16, 32, or 64) or
SCSGCLK
Each time the timer X underflows, the output of the
CNTR0 pin is inverted, and the corresponding Timer
X interrupt request bit is set to a “1”. The repeated
inversion of the CNTR0 pin output produces a rect-
angular waveform with a duty ratio of 50 percent. The
initial level of the output is determined by the CNTR0
polarity select bit (bit 6). When this bit is low, the out-
put starts from a high level. When this bit is high, the
output starts from a low level.
Event Counter Mode
Count Source: CNTR0
Timer countdown is triggered by inputs to the CNTR0
pin. Each time a timer underflows, the corresponding
timer interrupt request bit is set to a “1”, the contents
of the timer reload latch are loaded into the timer,
and the countdown sequence begins again.
The edge used to clock Timer X is determined by the
CNTR0 polarity select bit (bit 6).
Pulse Width Measurement Mode
Count Source:
F/n (where n is 8, 16, 32, or 64) or
SCSGCLK
This mode measures either the high or low-pulse
width of the signal on the CNTR0 pin. The pulse width
measured is determined by the CNTR0 polarity se-
lect bit (bit 6). When this bit is “0”, the high pulse is
measured. When this bit is “1”, the low pulse is mea-
sured.
The timer counts down while the level on the CNTR0
pin is the polarity selected by the CNTR0 polarity se-
lect bit. When the timer underflows, the Timer X in-
terrupt request bit is set to a “1”, the contents of the
timer reload latch are reloaded into the timer, and the
timer continues counting down. Each time the signal
polarity switches to the inactive state, a CNTR0 in-
terrupt occurs indicating that the pulse width has been
measured. The width of the measured pulse can be
found by reading Timer X during the CNTR0 inter-
rupt service routine.
相關PDF資料 |
PDF描述 |
|---|---|
| M37643M8-XXXHP | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37643F8HP | 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37700E2AFS | 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC80 |
| M37700E2AXXXFP | 16-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80 |
| M37701E2-XXXSP | 16-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37640E8FS | 功能描述:EPROM MCU/8BIT CMOS EMULATION CH RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE |
| M37640M4T | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-111FP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-126FP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37640M8-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE CHIP 8 BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。