參數資料
型號： M37640E8FP
元件分類： 微控制器/微處理器
英文描述： 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQFP80
封裝： 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數： 39/96頁
文件大?。?/td> 1477K
代理商： M37640E8FP
44
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
Reserved
OER
FER
PER
RBF
TBE
TCM
MSB
7
LSB
0
Address: 0032
16 ,003A16
Access: Read only
Reset: 03
16
SER
TCM
Transmission complete (Transmission Register empty) Flag (Bit 0)
0: Data in Transmission Register
1: No data in Transmission Register
TBE
TX Buffer Empty flag (Bit 1)
0: Data in TX Buffer
1: No data in the TX Buffer
RBF
RX Buffer Full Flag (Bit 2)
0: No data in RX Buffer
1: Data in RX Buffer
PER
Receive Parity Error Flag (Bit 3)
0: No parity error received
1: Received framing error
FER
Receive Framing Error Flag (Bit 4)
0: No framing error received
1: Received framing error
OER
Receive Overrun Flag (Bit 5)
0: No overrun receive received
1: Received overrun
SER
Receive Error Sum flag (Bit 6)
0: No error received
1: Received error
Bit 7
Reserved (Read “0”)
Fig. 1.44. UART Status Register (U1STS, U2STS)
1.19.4 Transmit/Receive Methods
1.19.4.1 Transmit Method
Setup
Define the baud rate by writing a value from 0-255 into
the UxBRG (see Figure 1.45).
Set the Transmission Initialization Bit (TIN, bit 2 of
UxCON), to “1”. This will reset the transmit status to a
value of 0316.
Select the interrupt source to be either TBE or TCM
by clearing or setting the Transmit Interrupt Source Se-
lection Bit (TIS, bit 4 of UxCON).
Configure the data format and clock selection by writ-
ing the appropriate value to UxMOD.
Set the Clear-To-Send Enable Bit (CTS_SEL, bit 5 of
UxCON), if CTS handshaking will be used.
Set the Transmit Enable Bit (TEN, bit 0 of UxCON), to
“1”.
Operation
When data is written to the low-order byte of the trans-
mit buffer (UxTRB1), TBE is cleared to “0”. If 9-bit
character length has been selected, the high-order byte
of the transmit buffer (UxTRB2) should be written before
the low-order byte (UxTRB1).
If no data is being shifted out of the transmit shift reg-
ister and CTS handshaking is disabled, the data written
to the transmit buffer is transferred to the transmit shift
register and the TCM flag in UxSTS is cleared to a “0”.
In addition, the TBE flag is set to a “1”, signaling that
the next byte of data can be written to the transmit
buffer. If CTS handshaking is enabled, the operation de-
scribed above does not take place until CTSx is
brought low.
Data from the transmit shift register is transmitted one
bit at a time beginning with the start bit and ending with
the stop bit. Note that the LSB is transmitted first.
If the TEN bit is cleared to a “0” while data is still be-
ing transmitted, the transmitter will continue until the
last bit is sent. This is also the case when CTS hand-
shaking is enabled and CTSx is brought back high
during transmission.
When the last bit is transmitted, the TCM flag is set to
a “1” if the transmit buffer is empty, TEN is a “0”, or
CTS handshaking is enabled and CTSx is “1”. If the
transmit buffer is not empty, TEN is a “1”, and CTS
handshaking is disabled or CTS handshaking is en-
abled and CTSx is low, the TCM flag is not set
because transfer of the contents of the transmit buffer
to the transmit shift register occurs immediately.
相關PDF資料
PDF描述
M37643M8-XXXHP 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37643F8HP 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80
M37700E2AFS 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC80
M37700E2AXXXFP 16-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80
M37701E2-XXXSP 16-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP64
相關代理商/技術參數
參數描述
M37640E8FS 功能描述:EPROM MCU/8BIT CMOS EMULATION CH RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230，RCB231，RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
M37640M4T 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-111FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-126FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37640M8-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE CHIP 8 BIT CMOS MICROCOMPUTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*