參數資料
型號: M306V5EESP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PDIP64
封裝: 0.750 INCH, PLASTIC, SDIP-64
文件頁數: 137/152頁
文件大?。?/td> 1963K
代理商: M306V5EESP
M306V5ME-XXXSP
M306V5EESP
MITSUBISHI MICROCOMPUTERS
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
38
Rev. 1.0
2.7.3 Hardware Interrupts
Hardware interrupts are classified into two types — special interrupts and peripheral I/O interrupts.
(1) Special interrupts
Special interrupts are non-maskable interrupts.
Reset
____________
Reset occurs if an “L” is input to the RESET pin.
________
DBC interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances.
Watchdog timer interrupt
Generated by the watchdog timer.
Single-step interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances. With the debug
flag (D flag) set to “1,” a single-step interrupt occurs after one instruction is executed.
Address match interrupt
An address match interrupt occurs immediately before the instruction held in the address indicated
by the address match interrupt register is executed with the address match interrupt enable bit set to
“1.” If an address other than the first address of the instruction in the address match interrupt register
is set, no address match interrupt occurs. For address match interrupt, see 2.11 Address match
Interrupt.
(2) Peripheral I/O interrupts
A peripheral I/O interrupt is generated by one of built-in peripheral functions. Built-in peripheral func-
tions are dependent on classes of products, so the interrupt factors too are dependent on classes of
products. The interrupt vector table is the same as the one for software interrupt numbers 0 through
31 the INI instruction uses. Peripheral I/O interrupts are maskable interrupts.
Bus collision detection interrupt
This is an interrupt that the serial I/O bus collision detection generates.
DMA0 interrupt, DMA1 interrupt
These are interrupts DMA generates.
VSYNC interrupt
VSYNC interrupt occurs if a VSYNC edge is input.
A-D conversion interrupt
This is an interrupt that the A-D converter generates.
UART0 transmission, UART2 transmission interrupts
These are interrupts that the serial I/O transmission generates.
UART0 reception, UART2 reception interrupts
These are interrupts that the serial I/O reception generates.
Multi-master I2C-BUS interface 0 and multi-master I2C-BUS interface 1 interrupts
This is an interrupt that the serial I/O transmission/reception is completed, or a STOP condition is
detected.
Timer A0 interrupt through timer A4 interrupt
These are interrupts that timer A generates
Timer B0 interrupt through timer B2 interrupt
These are interrupts that timer B generates.
相關PDF資料
PDF描述
M306V7FJAFP 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100
M306V7MJA-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
M30833FJFP 32-BIT, FLASH, 30 MHz, MICROCONTROLLER, PQFP100
M30833MJFP 32-BIT, MROM, 30 MHz, MICROCONTROLLER, PQFP100
M30833MJGP 32-BIT, MROM, 30 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M306V5EESS 功能描述:EPROM MCU/M16C(TV/VTR) RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230,RCB231,RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
M306V5ME 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M306V5ME-101SP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M306V5ME-105SPZ 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M306V5ME-XXXSP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER