PHY XS (Serial) Loopback (4.0.14 & 4.C004.[11:8]) The PHY XS loopback is implemented from the output of the TXP[3:0] serializers to " />
參數資料
型號： ISL35822IK
廠商： Intersil
文件頁數： 6/75頁
文件大?。?/td> 0K
描述： IC CLOCK/DATA RECOVERY 192EBGA-B
標準包裝： 90
類型： 時鐘和數據恢復（CDR），多路復用器
PLL： 無
輸入： CML
輸出： CML，CMOS
電路數： 1
比率 - 輸入:輸出： 8:8
差分 - 輸入:輸出： 是/是
頻率 - 最大： 3.1875Gbps
電源電壓： 1.425 V ~ 1.575 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 192-EBGA
供應商設備封裝： 192-EBGA-B（17x17）
包裝： 托盤
14
PHY XS (Serial) Loopback (4.0.14 & 4.C004.[11:8])
The PHY XS loopback is implemented from the output of the
TXP[3:0] serializers to the input multiplexers in front of the
RXP[3:0] CDRs. All four lanes are controlled by bit 4.0.14,
while the individual lanes can be controlled (one at a time) by
the 4.C004’h.[11:8] bits. Assuming that this is the only
loopback enabled, and that the BIST and test pattern
generation features are not enabled, the signal flow is from
the RCX[3:0][P/N] pins through almost all the ‘ingress’
channel to the input of the (still active) TXP[3:0] output drivers,
then (bypassing the RXP[3:0][P/N] inputs, the equalizers and
LOS detectors) back from the CDRs through almost all the
‘egress’ channel to the TCX[3:0][P/N] pins.
PCS Parallel Network Loopback (3.C004.[3:0])
This loopback is implemented (at the internal XGMII-like level)
from the output of the RXFIFOs in the ‘ingress’ channel to the
input of the TXFIFOs in the ‘egress’ channel. The individual
lanes can be controlled (one at a time) by the 3.C004’h.[3:0]
bits. Assuming that this is the only loopback enabled, and that
the BIST and test pattern generation features are not enabled,
the signal flow is from the RCX[3:0][P/N] pins through the
PMA/PMD and PCS and again PMA/PMD to the
TCX[3:0][P/N] pins. This could also be seen as a ‘short’
loopback at the XGMII input of the PHY XS.
PCS (Parallel) Loopback (4.C004.[3:0] & Optionally
3.0.14)
This loopback is implemented (at the internal XGMII-like level)
from the output of the RXFIFOs in the ‘egress’ channel to the
input of the TXFIFOs in the ‘ingress’ channel. The individual
lanes can be controlled (one at a time) by the 4.C004’h.[3:0]
bits. If the enable bit in 3.C001.7 (Table 64) is set, all four
lanes can be controlled by bit 3.0.14. Since the latter is
specifically excluded by subclause 45.2.3.1.2 of the IEEE
802.3ae-2002 specification for a 10GBASE-X PCS, the
default is to NOT enable this loopback bit, and if it is enabled,
the ISL35822 does not conform to the IEEE specification. A
maintenance request has been submitted to the IEEE to
enable this loopback bit as optional, and to allow a ‘PCS
Loopback Capability’ bit in register bit 3.24.10 (see
http://www.ieee802.org/3/maint/requests/maint_1113.pdf), but
this has so far been rejected, and may never be approved.
Assuming that this is the only loopback enabled, and that the
BIST and test pattern generation features are not enabled, the
signal flow is from the RXP[3:0][P/N] pins through the full PHY
XS via the internal XGMII to the TXP[3:0][P/N] pins. This
could also be seen as a ‘short’ loopback at the XGMII input of
the PCS.
PLL LOCK
FAIL
IEEE REG
1.8.11
See LASI
TXFAULT
IEEE REG
1.1.7
IEEE REG
1.8.10
See LASI
IEEE REG
1.10.0
IEEE REG
1.10.4:1
CX4
LX4
OPRLOS
[3:0]
REG
1.C00A.7:4
REG
1.C01D.6
PCS
BYTE
SYNC
PCS
LANE
ALIGN
IEEE REG
3.1.2
PHY XS
BYTE
SYNC
PHY XS
LANE
ALIGN
IEEE REG
3.1.7
IEEE REG
3.8.11
IEEE REG
3.8.10
See LASI
IEEE REG
3.24.3:0
IEEE REG
3.24.12
IEEE REG
4.1.7
IEEE REG
4.8.11
IEEE REG
4.8.10
See LASI
IEEE REG
4.24.12
IEEE REG
4.1.2
IEEE REG
4.24.3:0
REG
4.C00A.3:0
PHY XS
SIGNAL
DETECT
PMA/PMD
SIGNAL
DETECT
REG
1.C00A.3:0
CX4
SIGNAL_
DETECT
REG
1.C001.10:8
leve
l
REG
3.C001.10:8 level
CX4
LX4
IEEE REG
1.1.2
REG
1.C012h.13
POLARITY
See LASI
FIGURE 4. IEEE AND VENDOR SPECIFIC FAULT AND STATUS REGISTERS (EQUIVALENT SCHEMATIC)
ISL35822
相關PDF資料
PDF描述
VI-22Y-MX-S CONVERTER MOD DC/DC 3.3V 49.5W
VI-22Y-MW-S CONVERTER MOD DC/DC 3.3V 66W
MS27474E16B55PA CONN RCPT 55POS JAM NUT W/PINS
V24A24M300BF3 CONVERTER MOD DC/DC 24V 300W
D38999/24KC4SA CONN RCPT 4POS JAM NUT W/SCKT
相關代理商/技術參數
參數描述
ISL35822LP 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Octal 2.488Gbps to 3.187Gbps/ Lane Retimer
ISL35822LPIK 功能描述:IC CLOCK/DATA RECOVERY 192EBGA-B RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
ISL36111 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:11.1Gb/s Lane Extender
ISL36111DRZ-EVALZ 功能描述:EVAL BOARD FOR ISL36111DRZ RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
ISL36111DRZ-T7 功能描述:IC EQUALIZER REC 11.1GBPS 16QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:QLx™ 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*