- 您現在的位置：買賣IC網 > PDF目錄385273 > DS2154 (Maxim Integrated Products, Inc.) Enhanced E1 Single Chip Transceiver(改進型E1單片收發器) PDF資料下載
參數資料
| 型號： | DS2154 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Enhanced E1 Single Chip Transceiver(改進型E1單片收發器) |
| 中文描述： | 增強型E1單芯片收發器 |
| 文件頁數： | 18/71頁 |
| 文件大小： | 654K |
| 代理商： | DS2154 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
DS2154
071498 18/71
ADDRESS
REGISTER ABBREVIATION
REGISTER NAME
R/W
9E
R/W
Receive Channel 31.
RC31
9F
R/W
Receive Channel 32.
RC32
A0
R/W
Transmit Channel Control 1.
TCC1
A1
R/W
Transmit Channel Control 2.
TCC2
A2
R/W
Transmit Channel Control 3.
TCC3
A3
R/W
Transmit Channel Control 4.
TCC4
A4
R/W
Receive Channel Control 1.
RCC1
A5
R/W
Receive Channel Control 2.
RCC2
A6
R/W
Receive Channel Control 3.
RCC3
A7
R/W
Receive Channel Control 4.
RCC4
A8
R/W
Common Control 4.
CCR4
A9
R
Transmit DS0 Monitor.
TDS0M
AA
R/W
Common Control 5.
CCR5
AB
R
Receive DS0 Monitor.
RDS0M
AC
R/W
Test 3.
TEST3 (set to 00h)
AD
R/W
Not Used.
(set to 00h)
AE
R/W
Not Used.
(set to 00h)
AF
R/W
Not Used.
(set to 00h)
NOTES:
1. Test Registers 1, 2, and 3 are used only by the factory; these registers must be cleared (set to all zeros) on pow-
er–up initialization to insure proper operation.
2. Register banks Bxh, Cxh, Dxh, Exh, and Fxh are not accessible.
2.0
PARALLEL PORT
The DS2154 is controlled via either a non–multiplexed
(MUX=0) or a multiplexed (MUX=1) bus by an external
microcontroller or microprocessor. The DS2154 can
operate with either Intel or Motorola bus timing configu-
rations. If the BTS pin is tied low, Intel timing will be
selected; if tied high, Motorola timing will be selected.
All Motorola bus signals are listed in parenthesis (). See
the timing diagrams in the A.C. Electrical Characteris-
tics in Section 14 for more details.
3.0
The operation of the DS2154 is configured via a set of
nine control registers. Typically, the control registers
are only accessed when the system is first powered up.
Once the DS2154 has been initialized, the control regis-
ters will only need to be accessed when there is a
change in the system configuration. There are two
CONTROL, ID AND TEST REGISTERS
Receive Control Register (RCR1 and RCR2), two
Transmit Control Registers (TCR1 and TCR2), and five
Common Control Registers (CCR1 to CCR5). Each of
the nine registers are described in this section.
There is a device IDentification Register (IDR) at
address 0FH. The MSB of this read–only register is
fixed to a one indicating that the DS2154 is present. The
pin–for–pin compatible T1 version of the DS2154 also
has an ID register at address 0FH and the user can read
the MSB to determine which chip is present since in the
DS2154 the MSB will be set to a one and in the DS2152
it will be set to a zero. The lower four bits of the IDR are
used to display the die revision of the chip.
The Test Registers at addresses 15, 19, and AC hex are
used by the factory in testing the DS2154. On power–
up, the Test Registers should be set to 00 hex in order for
the DS2154 to operate properly.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2164Q | G.726 ADPCM Processor(G.726自適應音頻脈沖編碼處理器) |
| DS2175 | T1/CEPT Elastic Store(T1/CEPT 彈性存儲器) |
| DS2180A | T1 Transceiver(T1收發器) |
| DS2187 | Receive Line Interface(接收線接口) |
| DS2250T | Soft Microcontroller Module(軟件微控制器模塊) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2154DK | 功能描述:KIT DESIGN E1 DS2154 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| DS2154L | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154L+ | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154LA2 | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154LA2+ | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。