參數資料
型號: BX80528KL150GD
廠商: INTEL CORP
元件分類: 微控制器/微處理器
英文描述: 32-BIT, 1500 MHz, MICROPROCESSOR, CPGA603
封裝: PGA-603
文件頁數: 8/116頁
文件大小: 2277K
代理商: BX80528KL150GD
Intel XeonTM Processor MP
Datasheet
105
The thermal sensor internally decodes one of three upper address patterns from the bus of the form
“0011XXXZb”, “1001XXXZb”, or “0101XXXZb”. The device’s addressing, as implemented, uses
the SM_TS_A[1:0] pins in either the HI, LO, or Hi-Z state. Therefore, the thermal sensor supports
nine unique addresses. To set either pin for the Hi-Z state, the pin must be left floating. As before,
the “Z” bit is the read/write bit for the serial transaction.
Note that addresses of the form “0000XXXXb” are Reserved and should not be generated by an
SMBus master. The thermal sensor samples and latches the SM_TS_A[1:0] signals at power-up
and at the starting point of every conversion. System designers should ensure that these signals are
at valid input levels before the thermal sensor powers up. This should be done by pulling the pins to
SM_VCC or V
SS viaa1 K or smaller resistor, or leaving the pins floating to achieve the Hi-Z
state. If the designer desires to drive the SM_TS_A[1:0] pins with logic, the designer must ensure
that the pins are at input levels of 3.3V or 0V before SM_VCC begins to ramp. The system
designer must also ensure that their particular implementation does not add excessive capacitance
to the address inputs. Excess capacitance at the address inputs may cause address recognition
problems. Refer to the appropriate platform design guidelines document and the SMBus and I2C
Bus Design Guide application note.
Figure 36 on page 96 shows a logical diagram of the pin connections. Table 49 and Table 50
describe the address pin connections and how they affect the addressing of the devices.
Table 49. Thermal Sensor SMBus Addressing
NOTES:
1. Upper address bits are decoded in conjunction with the select pins.
2. A tri-state or “Z” state on this pin is achieved by leaving this pin unconnected.
Note:
System management software must be aware of the processor dependent addresses for the thermal
sensor.
Address (Hex)
Upper Address1
Device Select
8-bit Address Word on Serial Bus
SM_TS_A1
SM_TS_A0
b[7:0]
3Xh
0011
0
Z2
1
0
0011000Xb
0011001Xb
0011010Xb
5Xh
0101
0
Z2
1
Z2
0101001Xb
0101010Xb
0101011Xb
9Xh
1001
0
Z2
1
1001100Xb
1001101Xb
1001110Xb
相關PDF資料
PDF描述
BU-61740B3-200L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, PBGA128
BU-61740B4-200L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, PBGA128
BU-61740B4-400L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, PBGA128
BU-61840B3-300 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, PBGA128
BU-61840B3-302W 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, PBGA128
相關代理商/技術參數
參數描述
BX80530C1000256 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor
BX80530C1133256 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor
BX80530C1200256 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor
BX80530C1400512 制造商:Intel 功能描述:MPU PENTIUM III PROCESSOR 64-BIT 0.13UM 1.4GHZ 370-PIN FCPG - Boxed Product (Development Kits)
BX80530F1100256 制造商:Intel 功能描述:CELERON PROCESSOR - Boxed Product (Development Kits)