- 您現在的位置：買賣IC網 > Datasheet目錄58 > XBIB-U (Digi International/Maxstream)BOARD USB ZIGBEE MOD PRO Datasheet資料下載
參數資料
| 型號： | XBIB-U |
| 廠商： | Digi International/Maxstream |
| 文件頁數： | 34/72頁 |
| 文件大?。?/td> | 1116K |
| 描述： | BOARD USB ZIGBEE MOD PRO |
| 設計資源： | XBIB-U Shematic |
| 標準包裝： | 1 |
| 附件類型： | 接口板 |
| 適用于相關產品： | XBee 和 XBee Pro 收音機 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
XBee/XBeePRO"燨EM燫F燤odules??02.15.4?爒1.xAx燵2007.05.031]
2007燤axStream,營nc.
牋牋?4
Chapter??燫F燤odule燙onfiguration
3.3. Command Descriptions
Command descriptions in this section are listed alphabetically. Command categories are desig-
nated within "< >" symbols that follow each command title. XBee/XBee-PRO RF Modules expect
parameter values in hexadecimal (designated by the "0x" prefix).
All modules operating within the same network should contain the same firmware version.
A1 (End Device Association) Command
<Networking {Association}> The A1 command is
used to set and read association options for an
End Device.
Use the table below to determine End Device
behavior in relation to the A1 parameter.
A2 (Coordinator Association) Command
<Networking {Association}> The A2 command is
used to set and read association options of the
Coordinator.
Use the table below to determine Coordinator
behavior in relation to the A2 parameter.
The燽inary爀quivalent爋f爐he燿efault爒alue?0x06)爄s?0000110.?Bit?爄s爐he爈ast燿igit爋f爐he爏equence.
Bit number
End Device Association Option
0 - ReassignPanID
0 - Will only associate with Coordinator operating on PAN ID that matches Node Identifier
1 - May associate with Coordinator operating on any PAN ID
1 - ReassignChannel
0 - Will only associate with Coordinator operating on Channel that matches CH setting
1 - May associate with Coordinator operating on any Channel
2 - AutoAssociate
0 - Device will not attempt Association
1 - Device attempts Association until success
Note: This bit is used only for Non-Beacon systems. End Devices in a Beaconing system must
always associate to a Coordinator
3 - PollCoordOnPinWake
0 - Pin Wake will not poll the Coordinator for pending (indirect) Data
1 - Pin Wake will send Poll Request to Coordinator to extract any pending data
4 - 7
[reserved]
Bit number
End Device Association Option
0 - ReassignPanID
0 - Coordinator will not perform Active Scan to locate available PAN ID. It will operate on ID
(PAN ID).
1 - Coordinator will perform Active Scan to determine an available ID (PAN ID). If a PAN ID
conflict is found, the ID parameter will change.
1 - ReassignChannel
0 - Coordinator will not perform Energy Scan to determine free channel. It will operate on the
channel determined by the CH parameter.
1 - Coordinator will perform Energy Scan to find a free channel, then operate on that channel.
2 - AllowAssociate
0 - Coordinator will not allow any devices to associate to it.
1 - Coordinator will allow devices to associate to it.
3 - 7
[reserved]
AT Command: ATA1
Parameter Range: 0 - 0x0F [bitfield]
Default Parameter Value: 0
Related Commands: ID (PAN ID), NI (Node
Identifier), CH (Channel), CE (Coordinator
Enable), A2 (Coordinator Association)
Minimum Firmware Version Required: v1.x80
AT Command: ATA2
Parameter Range: 0 - 7 [bitfield]
Default Parameter Value: 0
Related Commands: ID (PAN ID), NI (Node
Identifier), CH (Channel), CE (Coordinator
Enable), A1 (End Device Association), AS
Active Scan), ED (Energy Scan)
Minimum Firmware Version Required: v1.x80
相關PDF資料 |
PDF描述 |
|---|---|
| XIB-E | BOARD INTERFACE ETHERNET |
| XIB-R | BOARD INTERFACE RS232/485 |
| ZMN2400HPDB | BOARD ROUTER DEV ZIGBEE 100MW |
| ZMN24HPDK-B | KIT DEV W/ZIGBEE ZMN2400HP |
| ZNI1000TC | IC TEMP SENSOR NI1000 SOT23-3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XBIB-U-DEV | 功能描述:界面開發工具 USB XBee-PRO profes onal interface board RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBIB-U-SP | 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Pads RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBIB-U-SS | 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Skt RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBL6450BYFVR | 制造商:Texas Instruments 功能描述:ECS BLUELINK - Tape and Reel |
| XBL6450YFHR | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。