參數資料
型號: XBIB-U
廠商: Digi International/Maxstream
文件頁數: 28/72頁
文件大小: 1116K
描述: BOARD USB ZIGBEE MOD PRO
設計資源: XBIB-U Shematic
標準包裝: 1
附件類型: 接口板
適用于相關產品: XBee 和 XBee Pro 收音機
XBee/XBeePRO"燨EM燫F燤odules??02.15.4?爒1.xAx燵2007.05.031]
2007燤axStream,營nc.
牋牋?8
Chapter??燫F燤odule燙onfiguration
A2 ( v1.x80*)
Networking
{Association}
Coordinator Association. Set/Read Coordinator association options. 
bit 0 - ReassignPanID
0 - Coordinator will not perform Active Scan to locate available PAN ID. It will operate
  on ID (PAN ID).
1 - Coordinator will perform Active Scan to determine an available ID (PAN ID). If a
  PAN ID conflict is found, the ID parameter will change.
bit 1 - ReassignChannel -
0 - Coordinator will not perform Energy Scan to determine free channel. It will operate
  on the channel determined by the CH parameter.
1 - Coordinator will perform Energy Scan to find a free channel, then operate on that
  channel.
bit 2 - AllowAssociation -
0 - Coordinator will not allow any devices to associate to it.
1 - Coordinator will allow devices to associate to it.
bits 3 - 7 are reserved
0 - 7 [bitfield]
0
AI ( v1.x80*)
Networking
{Association}
Association Indication. Read errors with the last association request:
0x00 - Successful Completion - Coordinator successfully started or End Device
  association complete
0x01 - Active Scan Timeout
0x02 - Active Scan found no PANs
0x03 - Active Scan found PAN, but the CoordinatorAllowAssociation bit is not set
0x04 - Active Scan found PAN, but Coordinator and End Device are not
  configured to support beacons
0x05 - Active Scan found PAN, but the Coordinator ID parameter does not match
  the ID parameter of the End Device
0x06 - Active Scan found PAN, but the Coordinator CH parameter does not match the
  CH parameter of the End Device
0x07 - Energy Scan Timeout
0x08 - Coordinator start request failed
0x09 - Coordinator could not start due to invalid parameter
0x0A - Coordinator Realignment is in progress
0x0B - Association Request not sent
0x0C - Association Request timed out - no reply was received
0x0D - Association Request had an Invalid Parameter
0x0E - Association Request Channel Access Failure. Request was not transmitted -
  CCA failure
0x0F - Remote Coordinator did not send an ACK after Association Request was sent
0x10 - Remote Coordinator did not reply to the Association Request, but an ACK was
  received after sending the request
0x11 - [reserved]
0x12 - Sync-Loss - Lost synchronization with a Beaconing Coordinator
0x13 - Disassociated - No longer associated to Coordinator
0 - 0x13 [read-only]
-
DA ( v1.x80*)
Networking
{Association}
Force Disassociation. End Device will immediately disassociate from a Coordinator (if 
associated) and reattempt to associate.
-
-
FP ( v1.x80*)
Networking
{Association}
Force Poll. Request indirect messages being held by a coordinator.
-
-
Table?02.   XBee/XBeePRO燙ommands?燦etworking?燬ecurity?/SPAN>(Subcategories?/SPAN>designated?/SPAN>within?/SPAN>{brackets})
AT 
Command
Command 
Category
Name and Description
Parameter Range
Default
相關PDF資料
PDF描述
XIB-E BOARD INTERFACE ETHERNET
XIB-R BOARD INTERFACE RS232/485
ZMN2400HPDB BOARD ROUTER DEV ZIGBEE 100MW
ZMN24HPDK-B KIT DEV W/ZIGBEE ZMN2400HP
ZNI1000TC IC TEMP SENSOR NI1000 SOT23-3
相關代理商/技術參數
參數描述
XBIB-U-DEV 功能描述:界面開發工具 USB XBee-PRO profes onal interface board RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBIB-U-SP 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Pads RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBIB-U-SS 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Skt RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBL6450BYFVR 制造商:Texas Instruments 功能描述:ECS BLUELINK - Tape and Reel
XBL6450YFHR 制造商:Texas Instruments 功能描述: