- 您現在的位置：買賣IC網 > PDF目錄372146 > SJA1000 (NXP SEMICONDUCTORS) Stand-alone CAN controller(單機CAN控制器) PDF資料下載
參數資料
| 型號： | SJA1000 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Stand-alone CAN controller(單機CAN控制器) |
| 中文描述： | 2 CHANNEL(S), 1M bps, LOCAL AREA NETWORK CONTROLLER, PDIP28 |
| 封裝： | 0.600 INCH, PLASTIC, DIP-28 |
| 文件頁數： | 17/68頁 |
| 文件大?。?/td> | 234K |
| 代理商： | SJA1000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
2000 Jan 04
17
Philips Semiconductors
Product specification
Stand-alone CAN controller
SJA1000
6.3.6
I
NTERRUPT
R
EGISTER
(IR)
The interrupt register allows the identification of an interrupt source. When one or more bits of this register are set, the
INT pin is activated (LOW). After this register is read by the microcontroller, all bits are reset what results in a floating
level at INT. The interrupt register appears to the microcontroller as a read only memory.
Table 6
Bit interpretation of the interrupt register (IR); CAN address 3
Notes
1.
2.
Reading this bit will always reflect a logic 1.
A wake-up interrupt is also generated if the CPU tries to set go to sleep while the CAN controller is involved in bus
activities or a CAN interrupt is pending.
The overrun interrupt bit (if enabled) and the data overrun status bit are set at the same time.
The receive interrupt bit (if enabled) and the receive buffer status bit are set at the same time.
It should be noted that the receive interrupt bit is cleared upon a read access, even if there is another message
available within the FIFO. The moment the release receive buffer command is given and there is another message
valid within the receive buffer, the receive interrupt is set again (if enabled) with the next t
scl
.
3.
4.
BIT
SYMBOL
WUI
NAME
VALUE
FUNCTION
IR.7
IR.6
IR.5
IR.4
Wake-Up Interrupt;
note 2
1
0
reserved; note 1
reserved; note 1
reserved; note 1
set; this bit is set when the sleep mode is left
reset; this bit is cleared by any read access of the
microcontroller
set; this bit is set on a ‘0-to-1’ transition of the data
overrun status bit, when the data overrun interrupt
enable is set to logic 1 (enabled)
reset; this bit is cleared by any read access of the
microcontroller
set; this bit is set on a change of either the error
status or bus status bits if the error interrupt
enable is set to logic 1 (enabled)
reset; this bit is cleared by any read access of the
microcontroller
set; this bit is set whenever the transmit buffer
status changes from logic 0 to logic 1 (released)
and transmit interrupt enable is set to logic 1
(enabled)
reset; this bit is cleared by any read access of the
microcontroller
set; this bit is set while the receive FIFO is not
empty and the receive interrupt enable bit is set
to logic 1 (enabled)
reset; this bit is cleared by any read access of the
microcontroller
IR.3
DOI
Data Overrun Interrupt;
note 3
1
0
IR.2
EI
Error Interrupt
1
0
IR.1
TI
Transmit Interrupt
1
0
IR.0
RI
Receive Interrupt; note 4
1
0
相關PDF資料 |
PDF描述 |
|---|---|
| SJE1349 | NPN PLASTIC POWER TRANSISTOR |
| SK016R | SCRs |
| SK006V | SCRs |
| SK008D | Box-shaped pin header, Discrete wire crimping connection, Discrete wire connectors; HRS No: 543-0505-6 00; No. of Positions: 12; Connector Type: Wire; Contact Gender: Female; Contact Spacing (mm): 2; Terminal Pitch (mm): 2; Current Rating(Amps)(Max.): 2; Operating Temperature Range (degrees C): -30 to 85; General Description: Housing; For Discrete wire; Crimping |
| SK008L | SCRs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SJA1000/N1,112 | 功能描述:網絡控制器與處理器 IC STAND-ALONE CAN CONTROLLER RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| SJA1000/N1112 | 制造商:NXP Semiconductors 功能描述:IC CAN CONTROLLER 1000 DIP28 |
| SJA1000N | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Stand-alone CAN controller |
| SJA1000T | 制造商:NXP Semiconductors 功能描述: |
| SJA1000T/N,112 | 功能描述:網絡控制器與處理器 IC STAND ALONE CAN CONTROLLER RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。