- 您現在的位置：買賣IC網 > PDF目錄369957 > PD6710 (Intel Corp.) ISA-to-PC-Card (PCMCIA) Controllers PDF資料下載
參數資料
| 型號： | PD6710 |
| 廠商： | Intel Corp. |
| 英文描述： | ISA-to-PC-Card (PCMCIA) Controllers |
| 中文描述： | ISA -到- PC卡（PCMCIA）的控制器 |
| 文件頁數： | 31/138頁 |
| 文件大?。?/td> | 723K |
| 代理商： | PD6710 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁
ISA-to-PC-Card (PCMCIA) Controllers
—
PD6710/
’
22
Datasheet
31
Connection of Interrupt Pins
IRQ interrupts in PC-compatible systems are not generally shared by hardware. Therefore, each
device in the system using IRQ interrupts must have a unique interrupt line. Additionally, many
software applications assume that certain I/O devices use specific IRQ signals. To allow PC Cards
with differing I/O functionalities to be connected to appropriate nonconflicting IRQ locations, the
PD67XX can steer the interrupt signal from a PC Card to any one of the ten different hardware
interrupt lines.
For some I/O-type cards, software is written so that IRQ interrupts can be shared. The PD67XX
contains unique logic that allows IRQ interrupts to be shared under software control. This is
accomplished by programming the PD67XX to alternately pulse and then three-state the desired
interrupt pin, which has been programmed as an IRQ output. This unique IRQ interrupt sharing
technique can be controlled through software so that systems incapable of IRQ sharing have no
loss of functionality.
4.1.5
Alternate Functions of Interrupt Pins
The PD67XX has two interrupt pins that can be programmed for alternate functions: IRQ12/
LED_OUT* and IRQ15/RI_OUT*. In addition, the PD6722 allows IRQ9 and IRQ10 to be
programmed for system DMA transfer handshake functions.
4.1.5.1
IRQ12 as LED_OUT* Driver
If a disk-activity or card-cycle-activity indicator is desired, IRQ12/LED_OUT* can be
programmed as an open-collector LED driver, capable of driving most common LEDs. There is no
specific bit that programs the IRQ12 pin to become an LED driver; instead, whenever a socket
interface is programmed to support a drive status LED input or is programmed to show card
activity on the LED (as described below), the IRQ12 pin becomes reconfigured as an open-
collector LED driver.
The
Extension Control 1
register
’
s LED Activity Enable bit (extended index 03h bit 2) is used to
enable the LED being used to show card activity. When this bit is set, any type of read or write
cycles to the respective socket cause the IRQ12/LED_OUT* signal to be driven low for the
duration of the card activity.
The Drive LED Enable bit (
Misc Control 2
register bit 4) is used to enable the BVD2/-SPKR/-
LED input from an I/O-interfaced card to be interpreted as a drive LED input, where an open-
collector signal driven low on this input will cause the IRQ12/LED_OUT* open-collector output to
go low.
Any combination of settings of LED Activity Enable and Drive LED Enable bits can be used on
each socket, with each type of activity being able to separately cause the LED to be illuminated.
Status from non-present or non-activated cards is automatically masked off from causing the
IRQ12/LED_OUT* signal to be driven low.
4.1.5.2
IRQ15 as RI_OUT*
If the capability to
‘
wake up
’
a system on an incoming phone call to a PC Card modem is desired,
it may be necessary in some systems to use a dedicated wakeup signal to the system
’
s SMI or NMI
controller to facilitate this instead of using the normal interrupt connections. If this is the case, the
IRQ15 connection can be reprogrammed to pass through a qualified version of an I/O interfaced
card
’
s -RI signal.
相關PDF資料 |
PDF描述 |
|---|---|
| PD7-20-70A | Analog IC |
| PD7-80-70A | Analog IC |
| PD7-40-70A | Analog IC |
| PD700A7 | Optoelectronic |
| PDA2446-B-AP | Analog Pigtailed PIN Photodiodes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PD67108AM | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:24-Channel PoE AF and AT DIMM |
| PD67108MAC-0212 | 制造商:Microsemi Corporation 功能描述:POE PSE MODULES - Bulk |
| PD67108MAC-GGGG | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:24-Channel PoE AF and AT DIMM |
| PD67108MDC-0212 | 制造商:Microsemi Corporation 功能描述:POE PSE MODULES - Bulk |
| PD67108MDC-GGGG | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:24-Channel PoE AF and AT DIMM |
發布緊急采購，3分鐘左右您將得到回復。