- 您現在的位置：買賣IC網 > PDF目錄1948 > MC68711E20VFNE2 (Freescale Semiconductor)IC MCU 8BIT 52-PLCC PDF資料下載
參數資料
| 型號： | MC68711E20VFNE2 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 69/138頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU 8BIT 52-PLCC |
| 標準包裝： | 23 |
| 系列： | HC11 |
| 核心處理器： | HC11 |
| 芯體尺寸： | 8-位 |
| 速度： | 4MHz |
| 連通性： | SCI，SPI |
| 外圍設備： | POR，WDT |
| 輸入/輸出數： | 38 |
| 程序存儲器容量： | 20KB（20K x 8） |
| 程序存儲器類型： | OTP |
| EEPROM 大小： | 512 x 8 |
| RAM 容量： | 768 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 數據轉換器： | A/D 8x8b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 105°C |
| 封裝/外殼： | 52-LCC（J 形引線） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁
Central Processor Unit (CPU)
MC68HC711D3 Data Sheet, Rev. 2.1
36
Freescale Semiconductor
At the end of the interrupt service routine, a return-from interrupt (RTI) instruction is executed. The RTI
instruction causes the saved registers to be pulled off the stack in reverse order. Program execution
resumes at the return address.
Certain instructions push and pull the A and B accumulators and the X and Y index registers and are often
used to preserve program context. For example, pushing accumulator A onto the stack when entering a
subroutine that uses accumulator A and then pulling accumulator A off the stack just before leaving the
subroutine ensures that the contents of a register will be the same after returning from the subroutine as
it was before starting the subroutine.
3.2.5 Program Counter (PC)
The program counter, a 16-bit register, contains the address of the next instruction to be executed. After
reset, the program counter is initialized from one of six possible vectors, depending on operating mode
and the cause of reset.
See Table 3-1.
3.2.6 Condition Code Register (CCR)
This 8-bit register contains:
Five condition code indicators (C, V, Z, N, and H)
Two interrupt masking bits (IRQ and XIRQ)
One stop disable bit (S)
In the M68HC11 CPU, condition codes are updated automatically by most instructions. For example, load
accumulator A (LDAA) and store accumulator A (STAA) instructions automatically set or clear the N, Z,
and V condition code flags. Pushes, pulls, add B to X (ABX), add B to Y (ABY), and transfer/exchange
instructions do not affect the condition codes. Refer to Table 3-2, which shows what condition codes are
affected by a particular instruction.
3.2.6.1 Carry/Borrow (C)
The C bit is set if the arithmetic logic unit (ALU) performs a carry or borrow during an arithmetic operation.
The C bit also acts as an error flag for multiply and divide operations. Shift and rotate instructions operate
with and through the carry bit to facilitate multiple-word shift operations.
3.2.6.2 Overflow (V)
The overflow bit is set if an operation causes an arithmetic overflow. Otherwise, the V bit is cleared.
3.2.6.3 Zero (Z)
The Z bit is set if the result of an arithmetic, logic, or data manipulation operation is 0. Otherwise, the Z
bit is cleared. Compare instructions do an internal implied subtraction and the condition codes, including
Z, reflect the results of that subtraction. A few operations (INX, DEX, INY, and DEY) affect the Z bit and
no other condition flags. For these operations, only = and
≠ conditions can be determined.
Table 3-1. Reset Vector Comparison
Mode
POR or RESET Pin
Clock Monitor
COP Watchdog
Normal
$FFFE, $FFFF
$FFFC, $FFFD
$FFFA, $FFFB
Test or boot
$BFFE, $BFFF
$BFFC, $FFFD
$BFFA, $FFFB
相關PDF資料 |
PDF描述 |
|---|---|
| MC68882RC50A | IC COPROCESSOR FLOAT PT 68-PGA |
| MC68908GR16CFJE | IC MCU 16K FLASH 8MHZ SPI 32LQFP |
| MC68E360ZQ25VLR2 | IC MPU QUICC 32BIT 357-PBGA |
| MC68EC000EI8R2 | IC MPU 32BIT 85MHZ 68-PLCC |
| MC68EC030FE25CB1 | IC MPU 32BIT ENH 25MHZ 132-CQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC6875 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:CLOCK GENERATOR/DRIVER (SCHOTTKY MONOLITHIC INTEGRATED CIRCUIT) |
| MC6875A | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:CLOCK GENERATOR/DRIVER (SCHOTTKY MONOLITHIC INTEGRATED CIRCUIT) |
| MC6875AL | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:CLOCK GENERATOR/DRIVER (SCHOTTKY MONOLITHIC INTEGRATED CIRCUIT) |
| MC6875L | 制造商:MOTOROLA 功能描述:IC |
| MC688 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS |
發布緊急采購，3分鐘左右您將得到回復。