參數資料
型號： M29DW640F70N6F
廠商： STMICROELECTRONICS
元件分類： PROM
英文描述： 4M X 16 FLASH 3V PROM, 70 ns, PDSO48
封裝： 12 X 20 MM, LEAD FREE, PLASTIC, TSOP-48
文件頁數： 15/74頁
文件大?。?/td> 556K
代理商： M29DW640F70N6F
Command interface
M29DW640F
The Extended Block Status of the Extended Block can be read using a read operation, A6,
A3 and A2, at VIL, A0 and A1, at VIH, and A21-A19 set to Bank Address A. The other bits
may be set to either VIL or VIH (Don't Care). If the Extended Block is "Factory Locked" then
80h is output on Data Input/Outputs DQ0-DQ7, otherwise 00h is output.
4.1.3
Read CFI Query command
The Read CFI Query Command is used to put the addressed bank in Read CFI Query
mode. Once in Read CFI Query mode Bus Read operations to the same bank will output
data from the Common Flash Interface (CFI) Memory Area. If the read operations are to a
different bank from the one specified in the command then the read operations will output
the contents of the memory array and not the CFI data.
One Bus Write cycle is required to issue the Read CFI Query Command. Care must be
taken to issue the command to one of the banks (A21-A19) along with the address shown in
Table 4 and Table 5 (A-1, A0-A10). Once the command is issued subsequent Bus Read
operations in the same bank (A21-A19) to the addresses shown in Appendix B (A7-A0), will
read from the Common Flash Interface Memory Area.
This command is valid only when the device is in the Read Array or Autoselected mode. To
enter Read CFI query mode from Auto Select mode, the Read CFI Query command must
be issued to the same bank address as the Auto Select command, otherwise the device will
not enter Read CFI Query mode.
The Read/Reset command must be issued to return the device to the previous mode (the
Read Array mode or Autoselected mode). A second Read/Reset command would be
needed if the device is to be put in the Read Array mode from Autoselected mode.
the information contained in the Common Flash Interface (CFI) memory area.
4.1.4
Chip Erase command
The Chip Erase command can be used to erase the entire chip. Six Bus Write operations
are required to issue the Chip Erase Command and start the Program/Erase Controller.
If any blocks are protected then these are ignored and all the other blocks are erased. If all
of the blocks are protected the Chip Erase operation appears to start but will terminate
within about 100s, leaving the data unchanged. No error condition is given when protected
blocks are ignored.
During the erase operation the memory will ignore all commands, including the Erase
Suspend command. It is not possible to issue any command to abort the operation. Typical
chip erase times are given in Table 8. All Bus Read operations during the Chip Erase
operation will output the Status Register on the Data Inputs/Outputs. See the section on the
Status Register for more details.
After the Chip Erase operation has completed the memory will return to the Read Mode,
unless an error has occurred. When an error occurs the memory will continue to output the
Status Register. A Read/Reset command must be issued to reset the error condition and
return to Read Mode.
The Chip Erase Command sets all of the bits in unprotected blocks of the memory to ’1’. All
previous data is lost.
相關PDF資料
PDF描述
M29F002BB120K1 2 Mbit 256Kb x8, Boot Block Single Supply Flash Memory
M29F016D90M6F 2M X 8 FLASH 5V PROM, 90 ns, PDSO44
M29F016D70N1E 2M X 8 FLASH 5V PROM, 70 ns, PDSO40
M29F100B-150M3TR 128K X 8 FLASH 5V PROM, 150 ns, PDSO44
M29F200B-90XM3 256K X 8 FLASH 5V PROM, 90 ns, PDSO44
相關代理商/技術參數
參數描述
M29DW640F70N6T 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:64 Mbit (8Mb x8 or 4Mb x16, Multiple Bank, Page, Boot Block) 3V Supply Flash Memory
M29DW640F70ZE1 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:64 Mbit (8Mb x8 or 4Mb x16, Multiple Bank, Page, Boot Block) 3V Supply Flash Memory
M29DW640F70ZE1E 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:64 Mbit (8Mb x8 or 4Mb x16, Multiple Bank, Page, Boot Block) 3V Supply Flash Memory
M29DW640F70ZE1F 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:64 Mbit (8Mb x8 or 4Mb x16, Multiple Bank, Page, Boot Block) 3V Supply Flash Memory
M29DW640F70ZE1T 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:64 Mbit (8Mb x8 or 4Mb x16, Multiple Bank, Page, Boot Block) 3V Supply Flash Memory
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*