- 您現在的位置：買賣IC網 > PDF目錄369885 > LXT386BE PCM TRANSCEIVER|QUAD|CEPT PCM-30/E-1|CMOS|BGA|160PIN|PLASTIC PDF資料下載
參數資料
| 型號： | LXT386BE |
| 英文描述： | PCM TRANSCEIVER|QUAD|CEPT PCM-30/E-1|CMOS|BGA|160PIN|PLASTIC |
| 中文描述： | 的PCM收發器|四|優稅PCM-30/E-1 |的CMOS | BGA封裝| 160PIN |塑料 |
| 文件頁數： | 27/80頁 |
| 文件大?。?/td> | 1112K |
| 代理商： | LXT386BE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
Octal T1/E1/J1 Transceiver
—
LXT384
Datasheet
27
2.3.1.3
Output Driver Power Supply
The output driver power supply (TVCC pins) can be either 3.3V or 5V nominal. When TVCC=5V,
LXT384 drives both E1 (75
/120
)
and T1 100
lines through a 1:2 transformer and 11
/
9.1
series resistors.
When TVCC=3.3V, the LXT384 drives E1 (75
/120
)
lines through a 1:2 transformer and 11
series resistor. A configuration with a 1:2 transformer and without series resistors should be used to
drive T1 100
lines.
The Channel 4 (TVCC4) power supply pin is used to determine 3.3V or 5.0V transmit operation.
Removing the series resistors for T1 applications with TVCC=3.3V, improves the power
consumption of the device. See
Table 36
.
On the other hand, series resistors in the transmit configuration improve the transmit return loss
performance. Good transmit return loss performance minimizes reflections in harsh cable
environments. In addition, series resistors provide protection against surges coupled to the device.
The resistors should be used in systems requiring protection switching without external relays.
Please refer to
Figure 6
for the recommended external line circuitry.
2.3.1.4
Power Sequencing
For the LXT384, we recommend sequencing TVCC first then VCC second or at the same time as
TVCC to prevent excessive current draw.
2.4
Driver Failure Monitor
The LXT384 transceiver incorporates an internal power Driver Failure Monitor (DFM) in parallel
with TTIP and TRING that is capable of detecting secondary shorts without cable. DFM is
available only in configurations with no transmit series resistors (T1 mode with TVCC=3.3V).
This feature is available in the serial and parallel host modes but not available in the hardware
mode of operation.
A capacitor, charged via a measure of the driver output current and discharged by a measure of the
maximum allowable current, is used to detect a secondary short failure. Secondary shorted lines
draw excess current, overcharging the cap. When the capacitor charge deviates outside the nominal
Table 2. Line Length Equalizer Inputs
LEN2
LEN1
LEN0
Line Length
1
Cable Loss
2
Operation Mode
0
1
1
0 - 133 ft. ABAM
133 - 266 ft. ABAM
266 - 399 ft. ABAM
399 - 533 ft. ABAM
533 - 655 ft. ABAM
0.6 dB
1.2 dB
1.8 dB
2.4 dB
3.0 dB
T1
1
0
0
1
0
1
1
1
0
1
1
1
0
0
0
E1 G.703, 75
coaxial cable and 120
twisted pair
cable.
E1
1. Line length from LXT384 to DSX-1 cross-connect point.
2. Maximum cable loss at 772KHz.
相關PDF資料 |
PDF描述 |
|---|---|
| LXT386LE | PCM TRANSCEIVER|QUAD|CEPT PCM-30/E-1|CMOS|QFP|100PIN|PLASTIC |
| LXT388LE | PCM TRANSCEIVER|DUAL|CEPT PCM-30/E-1|CMOS|QFP|100PIN|PLASTIC |
| LXT400JE | Hermetically Sealed, 3.3V, High Speed, High CMR, Logic Gate Optocoupler |
| LXT6155LE | Telecomm/Datacomm |
| LXT6251A | ATM/SONET MAPPER|CMOS|QFP|208PIN|PLASTIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LXT386LE | 制造商:LEVEL1 功能描述: |
| LXT388LE | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCM TRANSCEIVER|DUAL|CEPT PCM-30/E-1|CMOS|QFP|100PIN|PLASTIC |
| LXT400 | 制造商:LVL1 制造商全稱:LVL1 功能描述:All Rate Extended Range Switched 56/DDS Transceiver |
| LXT400JE | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Transceiver Circuit For Telecommunications |
| LXT441 | 制造商:LVL1 制造商全稱:LVL1 功能描述:Switched 56/DDS Integrated DSU/CSU |
發布緊急采購，3分鐘左右您將得到回復。