- 您現在的位置：買賣IC網 > PDF目錄382949 > EM6517 (Electronic Theatre Controls, Inc.) 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER PDF資料下載
參數資料
| 型號： | EM6517 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 4位微控制器 |
| 英文描述： | 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER |
| 中文描述： | 4位單片機的小型通用紅外遙控器 |
| 文件頁數： | 24/66頁 |
| 文件大?。?/td> | 762K |
| 代理商： | EM6517 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
EM6517
FOR ENGINEERING ONLY
EM Microelectronic-Marin SA, 09/99, Rev. A/277
24
8.2 Frequency Select and Up/Down Counting
8 different input clocks can be selected to drive the Counter. The selection is done with bits
CountFSel2…0
in
register
RegCCntl1
. 6 of this input clocks are coming from the prescaler. The maximum prescaler clock
frequency for the counter is half the system clock and the lowest is 1Hz. Therefore a complete counter roll over
can take as much as 17.07 minutes (1Hz clock, 10 bit length) or as little as 977
μ
s (Ck[15], 4 bit length). The
IRQCount0
, generated at each roll over, can be used for time bases, measurements length definitions, input
polling, wake up from Halt mode, etc. The
IRQCount0
and
IRQComp
are generated with the system clock
Ck[16] rising edge. IRQCount0 condition in up count mode is : reaching 3FF if 10-bit counter length (or FF, 3F,
F in 8, 6, 4-bit counter length). In down count mode the condition is reaching ‘0’. The non-selected bits are ‘don’t
care’. For IRQComp refer to section 8.4.
Note: The Prescaler and the Microprocessor clock’s are usually non-synchronous, therefore time bases
generated are max. n, min. n-1 clock cycles long (n being the selected counter start value in count down mode).
However the prescaler clock can be synchronized with μP commands using for instance the prescaler reset
function.
Figure 18. Counter Clock Timing
Prescaler Frequencies or Debounced Port A Clocks
The two remaining clock sources are coming from the PA[0] or PA[3] terminals. Refer to the Figure 12 on page
14 for details. Both sources can be either debounced (Ck[11] or Ck[8]) or direct inputs, the input polarity can
also be chosen. The output after the debouncer polarity selector is named PA3 , PA0 respectively. For the
debouncer and input polarity selection refer to chapter 7.2.4.
In the case of port A input clock without debouncer, the counting clock frequency will be half the input clock on
port A. The counter advances on every odd numbered port A negative edge ( divided clock is high level ).
IRQCount0 and IRQComp will be generated on the rising PA3 or PA0 input clock edge. In this condition the
EM6517-1 is able to count with a higher clock rate as the internal system clock (Hi-Frequency Input). Maximum
port A input frequency is limited to 200kHz. If higher frequencies are needed, please contact EM-Marin.
In both, up or down count (default) mode, the counter is cyclic. The counting direction is chosen in register
RegCCntl1
bit
Up/Down
(default ‘0’ is down count). The counter increases or decreases its value with each
positive clock edge of the selected input clock source. Start up synchronization is necessary because one can
not always know the clock status when enabling the counter. With EvCount=0, the counter will only start on the
next positive clock edge after a previously latched negative edge, while the
Start
bit was already set to ‘1’. This
synchronization is done differently if event count mode (bit
EvCount
) is chosen. Refer also to Figure 19.
Internal Clock Synchronization.
Non-D ebounced Port A Clocks (System Clock Independent)
System C lock
Prescaler Clock
Counting
Counter IRQ ’s
Divided C lock
System C lock
Port A Clock
Counting
Counter IRQ ’s
相關PDF資料 |
PDF描述 |
|---|---|
| emg6 | General purpose (dual digital transistors) |
| EMG6 | General purpose (dual digital transistors) |
| EMX-303L1 | Magnetic transducer Buzzer |
| EMX-303L2 | Magnetic transducer Buzzer |
| EMX-303P2 | Magnetic transducer Buzzer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EM6517-240# | 制造商:DANAHER - FLUKE 功能描述:BNC TO BANTAM CABLE 制造商:Fluke Electronics 功能描述:BNC TO BANTAM CABLE |
| EM6520 | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:MFP version of EM6620 Ultra Low Power Microcontroller 4x8 LCD Driver |
| EM6521 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4 bit Microcontroller |
| EM6522 | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:This board contains the different MFP’s |
| EM65240 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Graphic STN LCD Drivers |
發布緊急采購，3分鐘左右您將得到回復。