參數資料
型號: CYRF69213-40LFXC
廠商: CYPRESS SEMICONDUCTOR CORP
元件分類: 通信及網絡
英文描述: Programmable Radio on Chip Low Power
中文描述: SPECIALTY TELECOM CIRCUIT, QCC40
封裝: 6 X 6 MM, LEAD FREE, M0-220, QFN-40
文件頁數: 51/85頁
文件大?。?/td> 731K
代理商: CYRF69213-40LFXC
CYRF69213
Document #: 001-07552 Rev. *B
Page 51 of 85
Endpoint 0 Mode
Because both firmware and the SIE are allowed to write to the
Endpoint 0 Mode and Count Registers the SIE provides an
interlocking mechanism to prevent accidental overwriting of
data.
When the SIE writes to these registers they are locked and the
processor cannot write to them until after it has read them.
Writing to this register clears the upper four bits regardless of
the value written.
Table 78.Endpoint 0 Mode (EP0MODE) [0x44] [R/W]
Bit #
7
6
5
4
3
2
1
0
Field
Read/Write
Default
Bit 7
Setup
Received
R/C[3]
0
SETUP Received
This bit is set by hardware when a valid SETUP packet is received. It is forced HIGH from the start of the data packet phase of
the SETUP transactions until the end of the data phase of a control write transfer and cannot be cleared during this interval.
While this bit is set to ‘1’, the CPU cannot write to the EP0 FIFO. This prevents firmware from overwriting an incoming SETUP
transaction before firmware has a chance to read the SETUP data
This bit is cleared by any non-locked writes to the register
0 = No SETUP received
1 = SETUP received
IN Received
This bit, when set, indicates a valid IN packet has been received. This bit is updated to ‘1’ after the host acknowledges an IN
data packet.When clear, it indicates that either no IN has been received or that the host didn’t acknowledge the IN data by send-
ing an ACK handshake
This bit is cleared by any non-locked writes to the register.
0 = No IN received
1 = IN received
OUT Received
This bit, when set, indicates a valid OUT packet has been received and ACKed. This bit is updated to ‘1’ after the last received
packet in an OUT transaction. When clear, it indicates no OUT received
This bit is cleared by any non-locked writes to the register
0 = No OUT received
1 = OUT received
ACK’d Transaction
The ACK’d transaction bit is set whenever the SIE engages in a transaction to the register’s endpoint that completes with a ACK
packet
This bit is cleared by any non-locked writes to the register
1 = The transaction completes with an ACK
0 = The transaction does not complete with an ACK
Mode [3:0]
The endpoint modes determine how the SIE responds to USB traffic that the host sends to the endpoint. The mode controls how
the USB SIE responds to traffic and how the USB SIE will change the mode of that endpoint as a result of host packets to the
endpoint
IN Received
OUT Received
ACK’d Trans
Mode[3:0]
R/C[3]
0
R/C[3]
0
R/C[3]
0
R/W
0
R/W
0
R/W
0
R/W
0
Bit 6
Bit 5
Bit 4
Bits 3:0
[+] Feedback
相關PDF資料
PDF描述
CYRF6936-40LFXC WirelessUSB⑩ LP 2.4 GHz Radio SoC
CYS25G0101DX-ATC SONET OC-48 Transceiver
CYS25G0101DX-ATI SONET OC-48 Transceiver
CYS25G0101DX-ATXC SONET OC-48 Transceiver
CYS25G0101DX-ATXI SONET OC-48 Transceiver
相關代理商/技術參數
參數描述
CYRF69213-40LTXC 功能描述:8位微控制器 -MCU Programmable Radio on Chip Low Power RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
CYRF69213A-40LFXC 功能描述:8位微控制器 -MCU Programmable Radio on Chip Low Power RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
CYRF69213A-40LTXC 功能描述:射頻收發器 CYRF69213A-40LTXC RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
CYRF69303 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Programmable Radio-on-Chip LPstar
CYRF69303-40LFXC 功能描述:射頻微控制器 - MCU M8C 8bit 2.4GHz 8KB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:Si100x 數據總線寬度:8 bit 最大時鐘頻率:24 MHz 程序存儲器大小:64 KB 數據 RAM 大小:4 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LGA-42 安裝風格:SMD/SMT 封裝:Tube