- 您現在的位置：買賣IC網 > PDF目錄375384 > AX88196BLF (ASIX Electronics Corporation) Low-pin-count Non-PCI 8/16-bit 10/100M Fast Ethernet Controller with MII Interface PDF資料下載
參數資料
| 型號： | AX88196BLF |
| 廠商： | ASIX Electronics Corporation |
| 英文描述： | Low-pin-count Non-PCI 8/16-bit 10/100M Fast Ethernet Controller with MII Interface |
| 中文描述： | 低引腳數不符合信息產業部的PCI接口16位產品個10/100M快速以太網控制器 |
| 文件頁數： | 7/86頁 |
| 文件大?。?/td> | 551K |
| 代理商： | AX88196BLF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
ASIX ELECTRONICS CORPORATION
7
AX88196BLF
PME
O5/T5/8m
36
Wakeup Indicator: When programmed to do so, is asserted when
the AX88196B detects a wake event and is requesting the system
to wake up from the D1 sleep state. The polarity and buffer type
of this signal is programmable by BTCR (offset 15h)
Tab - 1 Local CPU bus interface signals group
2.2 10/100Mbps Twisted-Pair Interface pins group
Signal
Type
Pin No.
TPI+
AB
7
TPI-
AB
8
TPO+
AB
10
TPO-
AB
11
Description
Twisted Pair Receive Input, Positive
Twisted Pair Receive Input, Negative
Twisted Pair Transmit Output, Positive
Twisted Pair Transmit Output, Negative
RSET_BG
AO
1
Off-chip resister. Must be connected 12.1K ohm
±
1% to ground.
Tab - 2 10/100Mbps Twisted-Pair Interfaces pins group
2.3 Built-in PHY LED indicator pins group
Signal
Type
Pin No.
I_FULL/COL
I_SPEED
O5/8m
Description
O5/8m
26
Full-Duplex/Collision Status. If this signal is low, it indicates
full-duplex link established, and if it is high, then the link is in
half-duplex mode. When in half-duplex and collision occurrence, the
output will be driven low for 80ms and driven high at minimum 80ms.
Speed Status: If this signal is low, it indicates 100Mbps, and if it is
high, then the speed is 10Mbps.
Link Status/Active: If this signal is low, it indicates link, and if it is
high, then the link is fail. When in link status and line activity
occurrence, this signal is pulsed high (LED off) for 80ms whenever
transmit or receive activity is detected. This signal is then driven low
again for a minimum of 80ms, after which time it will repeat the
process if TX or RX activity is detected.
25
I_LK/ACT
O5/8m
24
Tab - 3 Built-in PHY LED indicator pins group
2.4 EEPROM Signals Group
Signal
Type
EECS
B5/4m/PD
EECK
B5/4m/PD
Pin No.
35
34
Description
EEPROM Chip Select: EEPROM chip select signal.
EEPROM Clock: Signal connected to EEPROM clock pin.
EECS, EECK can load BUS type setting during power on reset cycle.
EECS
0
0
1
1
EEPROM Data In/Out: Signal connected to EEPROM data input and
data output pin.
EECK
0
1
0
1
BUS TYPE
ISA BUS / SRAM-Like
80186
Reserved
MCS-51 (805X)
EEDIO
B5/4m/PU
33
Tab - 4 EEPROM bus interface signals group
相關PDF資料 |
PDF描述 |
|---|---|
| AX88658AB | 8-Port 10/100/1000BASE-T Ethernet Switch |
| AX88772_07 | USB to 10/100 Fast Ethernet/HomePNA Controller |
| AX88772 | USB to 10/100 Fast Ethernet/HomePNA Controller |
| AX88780_07 | IC,D/A CONVERTER,MC144110DW, 6-BIT,5-15V,SOIC-20,3-7US SER. |
| AX88780 | High-Performance Non-PCI Single-Chip 32-bit 10/100M Fast Ethernet Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AX88196L | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100BASE 3-in-1 Local CPU Bus Fast Ethernet Controller with Embedded SRAM |
| AX88613 | 制造商:ASIX 制造商全稱:ASIX 功能描述:ASIX Multi-Port Ethernet Controller |
| AX88615 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:5-Port 10/100BASE Ethernet Switch |
| AX88615P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:5-Port 10/100BASE Ethernet Switch |
| AX8863T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Dropout, 120mA Linear Regulators |
發布緊急采購，3分鐘左右您將得到回復。