- 您現在的位置：買賣IC網 > PDF目錄366584 > ARM60 (Mitel Networks Corporation) Low Power General Purpose 32-Bit RISC Microprocessor(低功耗通用32位精簡指令集微處理器) PDF資料下載
參數資料
| 型號： | ARM60 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | Low Power General Purpose 32-Bit RISC Microprocessor(低功耗通用32位精簡指令集微處理器) |
| 中文描述： | 低功耗通用32位RISC微處理器（低功耗通用32位精簡指令集微處理器） |
| 文件頁數： | 100/121頁 |
| 文件大?。?/td> | 1217K |
| 代理商： | ARM60 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁當前第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁
P60ARM-B
96
The correspondence between boundary-scan cells and system pins, system direction controls and system
output enables is as shown in
Table 25: Boundary Scan Signals & Pins
which they are connected in the boundary-scan register, starting with the cell closest to
scan register cells at input pins can apply tests to the on-chip core logic.
. The cells are listed in the order in
TDI
. All boundary-
The EXTEST guard values specified in
boundary-scan register (using the SAMPLE/PRELOAD instruction) before the EXTEST instruction is
selected, to ensure that known data is applied to the core logic during the test. The INTEST guard values
shown in the table below should be clocked into the boundary-scan register (using the SAMPLE/
PRELOAD instruction) before the INTEST instruction is selected to ensure that all outputs are disabled.
These guard values should also be used when new EXTEST or INTEST vectors are clocked into the
boundary-scan register.
Table 25: Boundary Scan Signals & Pins
should be clocked into the
The values stored in the BS register after power-up are not defined. Similarly, the values previously clocked
into the BS register are not guaranteed to be maintained across a Boundary Scan reset (from forcing nTRST
LOW or entering the Test Logic Reset state).
8.6.4 Output Enable Boundary-scan Cells
The boundary-scan register cells Nendout, Nabe, Ntbe, and Nmse control the output drivers of tristate
outputs as shown in the table 25. In the case of OUTEN0 enable cells (Nendout, Ntbe), loading a 1 into the
cell will place the associated drivers into the tristate state, while in the case of type INEN1 enable cells
(Nabe, Nmse), loading a 0 into the cell will tristate the associated drivers.
To put all ARM60 tristate outputs into their high impedance state, a logic 1 should be clocked into the
output enable boundary-scan cells Nendout and Ntbe, and a logic 0 should be clocked into Nabe and Nmse.
Alternatively, the HIGHZ instruction can be used.
If the on-chip core logic causes the drivers controlled by Nendout, for example, to be tristate, (i.e. by driving
the signal Nendout HIGH), then a 1 will be observed on this cell if the SAMPLE/PRELOAD or INTEST
instructions are active.
8.6.5 Single-step Operation
ARM60 is a static design and there is no minimum clock speed. It can therefore be single-stepped while the
INTEST instruction is selected. This can be achieved by serialising a parallel stimulus and clocking the
resulting serial vectors into the boundary-scan register. When the boundary-scan register is updated, new
test stimuli are applied to the core logic inputs; the effect of these stimuli can then be observed on the core
logic outputs by capturing them in the boundary-scan register.
相關PDF資料 |
PDF描述 |
|---|---|
| ARM610 | General Purpose 32-Bit Microprocessor with 4kByte Cache,Write Buffer and Memory Management Unit(通用32位微處理器（帶4K字節緩存，寫緩沖器和存儲器管理單元）) |
| ARRAYS | NIGHT VISION H.V. RECTIFIER DIODES & ARRAYS |
| ARS2540 | 40A GLASS PASSIVATED AVALANCHE BUTTON DIODE |
| AR2540 | 40A GLASS PASSIVATED AVALANCHE BUTTON DIODE |
| ARS25A | 25A AUTOMOTIVE BUTTON DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ARM607 | 制造商:Master Appliance Corp 功能描述:Armature, With Retaining Rings, 120V (HG 制造商:Master Appliance Corp 功能描述:Armature, With Retaining Rings, 120V (HG-751B) |
| ARM-607 | 制造商:Master Appliance Corp 功能描述:Nozzle Shield; HG-751B heat gun 制造商:Master Appliance 功能描述:Heat Gun,Armature W/Retaining Ring For Hg-751B 120V, Hg-501A-D |
| ARM610 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:General purpose 32-bit microprocessor |
| ARM7-009 | 制造商:Gravitech 功能描述:ARM7 LPC2378 W/2.8" TCH SCRN LCD BLU |
| ARM720T | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:General-purpose 32-bit Microprocessor with 8KB cache, enlarged Write buffer, and Memory Management Unit (MMU) combined in a single chip |
發布緊急采購，3分鐘左右您將得到回復。