- 您現在的位置：買賣IC網 > PDF目錄371440 > 29LV160BE (Fujitsu Limited) 16M (2M X 8/1M X 16) BIT PDF資料下載
參數資料
| 型號： | 29LV160BE |
| 廠商： | Fujitsu Limited |
| 英文描述： | 16M (2M X 8/1M X 16) BIT |
| 中文描述： | 16米（2米x 8/1M × 16）位 |
| 文件頁數： | 21/59頁 |
| 文件大小： | 653K |
| 代理商： | 29LV160BE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
MBM29LV160TE/BE
-70/90/12
21
Extended Command
(1) Fast Mode
MBM29LV160TE/BE has Fast Mode function. This mode dispenses with the initial two unlock cycles required
in the standard program command sequence writing Fast Mode command into the command register. In
this mode, the required bus cycle for programming is two cycles instead of four bus cycles in standard
program command. (Do not write erase command in this mode.) The read operation is also executed after
exiting this mode. To exit this mode, it is necessary to write Fast Mode Reset command into the command
register. (Refer to the Figure 26 Extended algorithm.) The V
CC
active current is required even CE = V
IH
during
Fast Mode.
(2) Fast Programming
During Fast Mode, the programming can be executed with two bus cycles operation. The Embedded Program
Algorithm is executed by writing program set-up command (A0H) and data write cycles (PA/PD). (Refer to
the Figure 26 Extended algorithm.)
(3) Extended Sector Protection
In addition to normal sector protection, the MBM29LV160TE/BE has Extended Sector Protection as extended
function. This function enable to protect sector by forcing V
ID
on RESET pin and write a commnad sequence.
Unlike conventional procedure, it is not necessary to force V
ID
and control timing for control pins. The only
RESET pin requires V
ID
for sector protection in this mode. The extended sector protect requires V
ID
on RESET
pin. With this condition, the operation is initiated by writing the set-up command (60H) into the command
register. Then, the sector addresses pins (A
19
, A
18
, A
17
, A
16
, A
15
, A
14
, A
13
and A
12
) and (A
6
, A
1
, A
0
) = (0, 1, 0)
should be set to the sector to be protected (recommend to set V
IL
for the other addresses pins), and write
extended sector protect command (60H). A sector is typically protected in 250
μ
s. To verify programming of
the protection circuitry, the sector addresses pins (A
19
, A
18
, A
17
, A
16
, A
15
, A
14
, A
13
and A
12
) and (A
6
, A
1
, A
0
) =
(0, 1, 0) should be set and write a command (40H). Following the command write, a logical “1” at device
output DQ
0
will produce for protected sector in the read operation. If the output data is logical “0”, please
repeat to write extended sector protect command (60H) again. To terminate the operation, it is necessary
to set RESET pin to V
IH
.
(4) CFI (Common Flash Memory Interface)
The CFI (Common Flash Memory Interface) specification outlines device and host system software
interrogation handshake which allows specific vendor-specified software algorithms to be used for entire
families of devices. This allows device-independent, JEDEC ID-independent, and forward-and backward-
compatible software support for the specified flash device families. Refer to CFI specification in detail.
The operation is initiated by writing the query command (98H) into the command register. Following the
command write, a read cycle from specific address retrives device information. Please note that output data
of upper byte (DQ
8
to DQ
15
) is “0” in word mode (16 bit) read. Refer to the CFI code table. To terminate
operation, it is necessary to write the read/reset command sequence into the register.
相關PDF資料 |
PDF描述 |
|---|---|
| 29LV160B | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160B | 16 Megabit (2 M x 8-Bit/1 M x 16-Bit) CMOS 3.0 Volt-only Boot Sector Flash Memory |
| 29LV160C-55R | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-70 | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-90 | 16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 29LV160BT-90V | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 29LV160C-55R | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-70 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160C-90 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:16M-BIT [2Mx8/1Mx16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY |
| 29LV160DB70EC | 制造商: 功能描述: 制造商:undefined 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。